M16CSLASH26 datasheet(212/239 Pages) RENESAS

212 / 239 page

Renesas Technology Corp.

Appendix Standard Serial I/O Mode (Flash Memory Version)

206

M16C/26 Group

SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER

Under

development

Preliminary Specifications Rev. 0.9

Specifications in this manual are tentative and subject to change.

Standard Serial I/O mode

The standard serial I/O mode inputs and outputs the software commands, addresses and data needed to

operate (read, program, erase, etc.) the internal flash memory using the serial I/O port UART1. The serial

I/O mode transfers the data serially in 8-bit units.

The standard serial I/O mode is different from the parallel I/O mode in that the CPU executes a control

program for flash memory rewrite (using the CPU's rewrite mode), rewrite data input and so forth. It is

started when both the P86(CE) pin and the CNVss pin are in “H” level after the reset is released. (In normal

operation mode, set CNVss pin to “L” level.)

Figure 1.22.1 shows the pin connections for the standard serial I/O mode.

There are actually two standard serial I/O modes: mode 1, which is clock synchronized, and mode 2, which

is asynchronized. Standard serial I/O switches between mode 1 (clock synchronous) and mode 2 (clock

asynchronous) depending on the level of CLK1 pin when the reset is released.

To use standard serial I/O mode 1 (clock synchronous), set the CLK1 pin to “H” level and release the reset.

The operation uses the four UART1 pins CLK1, RxD1, TxD1 and RTS1 (BUSY). The CLK1 pin is the transfer

clock input pin through which an external transfer clock is input. The TxD1 pin is for CMOS output. The

RTS1 (BUSY) pin outputs an “L” level when ready for reception and an "H" level when reception starts. In

mode 1, be sure the TXD1 (P67) pin is at high before reset being deasserted.

To use standard serial I/O mode 2 (clock asynchronous), set the CLK1 pin to “L” level and release the reset.

The operation uses the two UART1 pins RxD1 and TxD1.

In the standard serial I/O mode, only the user ROM area indicated in Figure 1.19.1 can be rewritten. In

addition, a 7-byte ID code exists to protect the device. When there is data in the flash memory, commands

sent from the peripheral unit are not accepted unless the ID code matches.

M16C/26 датащи(PDF) 212 Page - Renesas Technology Corp