M16CSLASH26 datasheet(45/239 Pages) RENESAS

45 / 239 page

Status Transition of BCLK

Renesas Technology Corp.

M16C/26 Group

SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER

Under

development

Preliminary Specifications Rev. 0.9

Specifications in this manual are tentative and subject to change.

Status Transition of BCLK

Power dissipation can be reduced and low-voltage operation achieved by changing the count source for

BCLK. Table 1.8.3 shows the operating modes corresponding to the settings of system clock control

registers 0 and 1.

When reset, the device starts in division by 8 mode. The main clock division select bit 0 (bit 6 at address

000616) and the XIN-XOUT drive capacity select bit (bit 5 at address 000716) change to “1” when shifting

from high-speed/medium-speed mode to stop mode, shifting to low power dissipation mode and at a reset.

When shifting from high-speed/medium-speed mode to low-speed mode, the value before high-speed/

medium-speed mode is retained. The following shows the operational modes of BCLK.

(1) Division by 2 mode

The main clock is divided by 2 to obtain the BCLK.

(2) Division by 4 mode

The main clock is divided by 4 to obtain the BCLK.

(3) Division by 8 mode

The main clock is divided by 8 to obtain the BCLK. When reset, the device starts operating from this

mode. Before the user can go from this mode to no division mode, division by 2 mode, or division by 4

mode, the main clock must be oscillating stably. When going to low-speed or lower power consumption

mode, make sure the sub-clock is oscillating stably.

(4) Division by 16 mode

The main clock is divided by 16 to obtain the BCLK.

(5) No-division mode

The main clock is divided by 1 to obtain the BCLK.

(6) Low-speed mode

fC is used as the BCLK. Note that oscillation of both the main and sub-clocks must have stabilized before

transferring from this mode to another or vice versa. At least 2 to 3 seconds are required after the sub-

clock starts. Therefore, the program must be written to wait until this clock has stabilized immediately

after powering up and after stop mode is cancelled.

(7) Low power dissipation mode

fC is the BCLK and the main clock is stopped.

M16C/26 датащи(PDF) 45 Page - Renesas Technology Corp