| поискавой системы для электроныых деталей |
|
CS4210 датащи(PDF) 76 Page - National Semiconductor (TI) |
|
|
|
|||||||||||||||||||||||||||||
CS4210 датащи(HTML) 76 Page - National Semiconductor (TI) |
|
76 / 102 page ![]() www.national.com 76 Revision 1.0 Register Descriptions (Continued) 4.4.19 Node ID and Status Register This register contains the CSR address for the node on which this chip resides. The 16-bit combination of busNum- ber and nodeNumber is referred to as the Node ID. This register is written autonomously and atomically by the CS4210 with the value in CS4103’s base register at Address 00h following the self-identification phase of bus initialization. Although IntEvent.phyRegRcvd (BAR0+Offset 80h[26]) is not set when the contents of CS4103’s base register at Address 00h are written here, software can use the IntEvent.selfIDComplete (BAR0+Offset 80h[16]) inter- rupt to detect that the self-identification phase has com- pleted and can then check for a new valid Node ID. Table 4-34. BAR0+Offset E8h: Node ID and Status Register Bit Name Access Reset Description 31 iDValid RU 0 ID Valid: This bit indicates whether or not the CS4210 has a valid node number. It is cleared when the bus reset state is detected and set again when the CS4210 receives a new node number from the CS4103. If iDValid is clear, software should not set ContextControl.run for either of the ATDMA contexts (request and response). 30 root RU 0 Root: This bit is set during the bus reset process if the CS4103 is root. 29:28 RSVD -- 0 Reserved 27 CPS RU 0 Cable Power Status: Set if the CS4103 is reporting that cable power status is OK (VP 8V). 26:16 RSVD -- 0 Reserved 15:6 busNumber RWU 3FFh Bus Number: This number is used to identify the specific 1394 bus this node belongs to when multiple 1394-compatible buses are connected via a bridge. This field is set to 3FFh on a bus reset. 5:0 nodeNumber RU Undef Node Number: This number is the physical node number established by the CS4103 during self-identification. It is automatically set to the value received from the CS4103 after the self-identification phase. If the CS4103 sets the nodeNumber to 63, software should not set ContextControl.run for either of the ATDMA contexts (request and response). |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |