| поискавой системы для электроныых деталей |
|
DP83916 датащи(PDF) 28 Page - National Semiconductor (TI) |
|
|
|
|||||||||||||||||||||||||||||
DP83916 датащи(HTML) 28 Page - National Semiconductor (TI) |
|
28 / 96 page ![]() 40 SONIC-16 Registers (Continued) 43 REGISTER DESCRIPTION 431 Command Register (Continued) (RAk50le0h) Bit Description 3 RXEN RECEIVER ENABLE Setting this bit enables the receive buffer management engine to begin buffering data to memory Setting this bit resets the RXDIS bit Note If this bit is set while the MAC unit is currently receiving a packet both RXEN and RXDIS are set until the network goes inactive (ie the SONIC-16 will not start buffering in the middle of a packet being received) 2 RXDIS RECEIVER DISABLE Setting this bit disables the receiver from buffering data to memory or the Receive FIFO If this bit is set during the reception of a packet the receiver is disabled only after the packet is processed The RXEN bit is reset when the receiver is disabled Tally counters remain active regardless of the state of this bit Note If this bit is set while the SONIC-16 is currently receiving a packet both RXEN and RXDIS are set until the packet is fully received 1 TXP TRANSMIT PACKET(S) Setting this bit causes the SONIC-16 to transmit packets which have been set up in the Transmit Descriptor Area (TDA) The SONIC-16 loads its appropriate registers from the TDA then begins transmission The SONIC-16 clears this bit after any of the following conditions have occurred (1) transmission had completed (ie after the SONIC-16 has detected EOL e 1) (2) the Halt Transmission command (HTX) has taken effect or (3) a transmit abort condition has occurred This condition occurs when any of the following bits in the TCR have been set EXC EXD FU or BCM Note This bit must not be set if a Load CAM operation is in progress (LCAM is set) The SONIC-16 will lock up if both bits are set simultaneously 0 HTX HALT TRANSMISSION Setting this bit halts the transmit command after the current transmission has completed TXP is reset after transmission has halted The Current Transmit Descriptor Address (CTDA) register points to the last descriptor transmitted The SONIC-16 samples this bit after writing to the TXpktstatus field 28 |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |