SC2200 datasheet(86/433 Pages) NSC

86 / 433 page

www.national.com

Revision 3.0

General Configuration Block (Continued)

Delay HSYNC. HSYNC delay by two TFT clock cycles.

0: There is no delay on HSYNC.

1: HYSNC is delayed twice by rising edge of TFT clock. Enables delay between VSYNC and HSYNC suited for TFT dis-

play.

Reserved. Write as read.

IBUS16 (Invert BUS16). This bit inverts the meaning of MCR[3] (bit 3 of this register).

0: BUS16 is as described for MCR[3].

1: BUS16 meaning is inverted: if MCR[3] = 0, ROMCS# access is 16 bits wide; if MCR[3] = 1, ROMCS# access is 8 bits

wide.

Reserved. Must be set to 0.

IO1ZWS (Enable ZWS# for IOCS1# Access). This bit enables internal activation of ZWS# (Zero Wait States) control for

IOCS1# access.

0: ZWS# is not active for IOCS1# access.

1: ZWS# is active for IOCS1# access.

IO0ZWS (Enable ZWS# for IOCS0# Access). This bit enables internal activation of ZWS# (Zero Wait States) control for

IOCS0# access.

0: ZWS# is not active for IOCS0# access.

1: ZWS# is active for IOCS0# access.

DOCZWS (Enable ZWS# for DOCCS# Access). This bit enables internal activation of ZWS# (Zero Wait States) control for

DOCCS# access.

0: ZWS# is not active for DOCCS# access.

1: ZWS# is active for DOCCS# access.

ROMZWS (Enable ZWS# for ROMCS# Access). This bit enables internal activation of ZWS# (Zero Wait States) control for

ROMCS# access.

0: ZWS# is not active for ROMCS# access.

1: ZWS# is active for ROMCS# access.

IO1_16 (Enable 16-Bit Wide IOCS1# Access). This bit enables the16-line access to IOCS1# in the Sub-ISA interface.

0: 8-bit wide IOCS1# access is used.

1: 16-bit wide IOCS1# access is used.

IO0_16 (Enable 16-Bit Wide IOCS0# Access). This bit enables the 16-line access to IOCS0# in the Sub-ISA interface.

0: 8-bit wide IOCS0# access is used.

1: 16-bit wide IOCS0# access is used.

DOC16 (Enable 16-Bit Wide DOCCS# Access). This bit enables the 16-line access to DOCCS# in the Sub-ISA interface.

0: 8-bit wide DOCCS# access is used.

1: 16-bit wide DOCCS# access is used.

Reserved. Write as read.

IRTXEN (Infrared Transmitter Enable). This bit enables drive of Infrared transmitter output.

0: IRTX+SOUT3 line (EBGA ball J3 / TEPBGA ball C11) is HiZ.

1: IRTX+SOUT3 line (EBGA ball J3 / TEPBGA ball C11) is enabled.

BUS16 (16-Bit Wide Boot Memory). (Read Only) This bit reports the status of the BOOT16 strap (EBGA ball G4 / TEP-

BGA ball C8). If the BOOT16 strap is pulled high, at reset 16-bit access to ROM in the Sub-ISA interface is enabled.

MCR[14] = 1 inverts the meaning of this register.

0: 8-bit wide ROM.

1: 16-bit wide ROM.

2:1

Reserved. Write as read.

Table 3-2. Multiplexing, Interrupt Selection, and Base Address Registers (Continued)

Bit

Description

SC2200 датащи(PDF) 86 Page - National Semiconductor (TI)

SC2200 датащи(HTML) 86 Page - National Semiconductor (TI)

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL