ATtiny167-ESSZ datasheet(62/282 Pages) ATMEL

62 / 282 page

7728D–AVR–07/09

ATtiny87/ATtiny167

External Interrupts

8.1

Overview

The External Interrupts are triggered by the INT1..0 pins or any of the PCINT15..0 pins.

Observe that, if enabled, the interrupts will trigger even if the INT1..0 or PCINT15..0 pins are

configured as outputs. This feature provides a way of generating a software interrupt.

The pin change interrupt PCINT1 will trigger if any enabled PCINT15..8 pin toggles. The pin

change interrupt PCINT0 will trigger if any enabled PCINT7..0 pin toggles. The PCMSK1 and

PCMSK0 Registers control which pins contribute to the pin change interrupts. Pin change

interrupts on PCINT15..0 are detected asynchronously. This implies that these interrupts can

be used for waking the part also from sleep modes other than Idle mode.

The INT1..0 interrupts can be triggered by a falling or rising edge or a low level. This is set up

as indicated in the specification for the External Interrupt Control Register A – EICRA. When

the INT1..0 interrupts are enabled and are configured as level triggered, the interrupts will trig-

ger as long as the pin is held low. The recognition of falling or rising edge interrupts on INT1..0

requires the presence of an I/O clock, described in “Clock Systems and their Distribution” on

page 24. Low level interrupts and the edge interrupt on INT1..0 are detected asynchronously.

This implies that these interrupts can be used for waking the part also from sleep modes other

than Idle mode. The I/O clock is halted in all sleep modes except Idle mode.

Note that if a level triggered interrupt is used for wake-up from Power-down or Power-save,

the required level must be held long enough for the MCU to complete the wake-up to trigger

the level interrupt. If the level disappears before the end of the Start-up Time, the MCU will still

wake up, but no interrupt will be generated. The start-up time is defined by the SUT and

CKSEL Fuses as described in “Clock Systems and their Distribution” on page 24.

8.2

Pin Change Interrupt Timing

An example of timing of a pin change interrupt is shown in Figure 8-1.

Figure 8-1.

Timing of pin change interrupts

clk

pin_lat

pin_sync

pcint_in[i]

PCINT[i]

PCINT[i] bit

(of PCMSKn)

clk

pcint_sync

pcint_set/flag

PCIFn

(interrupt flag)

PCINT[i] pin

pin_lat

pin_sync

clk

pcint_in[i]

pcint_syn

pcint_set/flag

PCIFn

ATtiny167-ESSZ датащи(PDF) 62 Page - ATMEL Corporation

ATtiny167-ESSZ датащи(HTML) 62 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL