HC705C9AGRSSLASHD datasheet(88/157 Pages) NXP

88 / 157 page

General Release Speciﬁcation

Start Bit Detection

MC68HC705C9A — Rev. 2.0

Serial Communications Interface (SCI)

9.12 Start Bit Detection

When the input (idle) line is detected low, it is tested for three more

sample times (referred to as the start edge verification samples in

Figure 9-4). If at least two of these three verification samples detect a

logic zero, a valid start bit has been detected; otherwise, the line is

assumed to be idle. A noise flag is set if all three verification samples do

not detect a logic zero. Thus, a valid start bit could be assumed with a

set noise flag present.

If a framing error has occurred without detection of a break (10 zeros for

8-bit format or 11 zeros for 9-bit format), the circuit continues to operate

as if there actually was a stop bit, and the start edge will be placed

artificially. The last bit received in the data shift register is inverted to a

logic one, and the three logic one start qualifiers (shown in Figure 9-4)

are forced into the sample shift register during the interval when

detection of a start bit is anticipated (see Figure 9-6); therefore, the start

bit will be accepted no sooner than it is anticipated.

If the receiver detects that a break (RDRF = 1, FE = 1, receiver data

artificially induced and the receiver must actually detect a logic one

before the start bit can be recognized (see Figure 9-7).

Freescale Semiconductor, Inc.

For More Information On This Product,

Go to: www.freescale.com

HC705C9AGRS/D датащи(PDF) 88 Page - NXP Semiconductors