AD9520-1SLASHPCBZ datasheet(7/80 Pages) AD

7 / 80 page

Data Sheet

AD9520-1

Rev. B | Page 7 of 80

CLOCK INPUTS

Table 3.

Parameter

Min

Typ

Max

Unit

Test Conditions/Comments

CLOCK INPUTS (CLK, CLK)

Differential input

Input Frequency

2.4

GHz

High frequency distribution (VCO divider)

2.0

GHz

Distribution only (VCO divider bypassed); this is the

frequency range supported by the channel divider for

all divide ratios except divide-by-17 and divide-by-3

1.6

GHz

Distribution only (VCO divider bypassed); this is the

frequency range supported by all channel divider ratios

Input Sensitivity, Differential

150

mV p-p

Measured at 2.4 GHz; jitter performance is improved

with slew rates > 1 V/ns; the input sensitivity is

sufficient for ac-coupled LVDS and LVPECL signals

Input Level, Differential

V p-p

Larger voltage swings can turn on the protection

diodes and can degrade jitter performance

Input Common-Mode Voltage, VCM

1.3

1.57

1.8

Self-biased; enables ac coupling

Input Common-Mode Range, VCMR

1.3

1.8

With 200 mV p-p signal applied; dc-coupled

Input Sensitivity, Single-Ended

150

mV p-p

CLK ac-coupled; CLK ac-bypassed to RF ground

Input Resistance

3.9

4.7

5.7

kΩ

Self-biased

Input Capacitance

Below about 1 MHz, the input should be dc-coupled. Care should be taken to match VCM.

CLOCK OUTPUTS

Table 4.

Parameter

Min

Typ

Max

Unit

Test Conditions/Comments

LVPECL CLOCK OUTPUTS

Termination = 50 Ω to VS_DRV − 2 V

OUT0, OUT1, OUT2, OUT3, OUT4,

OUT5, OUT6, OUT7, OUT8,

OUT9, OUT10, OUT11

Differential (OUT, OUT)

Output Frequency, Maximum

2400

MHz

Using direct to output (see Figure 20); higher frequencies

are possible, but the resulting amplitude does not meet

the VOD specification; the maximum output frequency is

limited by either the maximum VCO frequency or the

frequency at the CLK inputs, depending on the AD9520-1

configuration

Output High Voltage, VOH

VS_DRV − 1.07

VS_DRV − 0.96

VS_DRV −0.84

Output Low Voltage, VOL

VS_DRV − 1.95

VS_DRV − 1.79

VS_DRV −1.64

Output Differential Voltage, VOD

660

820

950

VOH − VOL for each leg of a differential pair for default

amplitude setting with the driver not toggling; the peak-

to-peak amplitude measured using a differential probe

across the differential pair with the driver toggling is

roughly 2× these values (see Figure 20 for variation over

frequency)

CMOS CLOCK OUTPUTS

OUT0A, OUT0B, OUT1A, OUT1B,

OUT2A, OUT2B, OUT3A, OUT3B,

OUT4A, OUT4B, OUT5A, OUT5B,

OUT6A, OUT6B, OUT7A, OUT7B,

OUT8A, OUT8B, OUT9A, OUT9B,

OUT10A, OUT10B, OUT11A,

OUT11B

Single-ended; termination = 10 pF

Output Frequency

250

MHz

See Figure 21

Output Voltage High, VOH

VS − 0.1

1 mA load, VS_DRV = 3.3 V/2.5 V

Output Voltage Low, VOL

0.1

1 mA load, VS_DRV = 3.3 V/2.5 V

Output Voltage High, VOH

2.7

10 mA load, VS_DRV = 3.3 V

Output Voltage Low, VOL

0.5

10 mA load, VS_DRV = 3.3 V

Output Voltage High, VOH

1.8

10 mA load, VS_DRV = 2.5 V

Output Voltage Low, VOL

0.6

10 mA load, VS_DRV = 2.5 V

AD9520-1/PCBZ датащи(PDF) 7 Page - Analog Devices

AD9520-1/PCBZ датащи(HTML) 7 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80

датащи скачать

ссылки URL