ISM330DLC datasheet(40/116 Pages) STMICROELECTRONICS

40 / 116 page

Digital interfaces

ISM330DLC

40/116

DocID030686 Rev 2

The Slave ADdress (SAD) associated to the ISM330DLC is 110101xb. The SDO/SA0 pin

can be used to modify the less significant bit of the device address. If the SDO/SA0 pin is

connected to the supply voltage, LSb is ‘1’ (address 1101011b); else if the SDO/SA0 pin is

connected to ground, the LSb value is ‘0’ (address 1101010b). This solution permits to

connect and address two different inertial modules to the same I2C bus.

Data transfer with acknowledge is mandatory. The transmitter must release the SDA line

during the acknowledge pulse. The receiver must then pull the data line LOW so that it

remains stable low during the HIGH period of the acknowledge clock pulse. A receiver

which has been addressed is obliged to generate an acknowledge after each byte of data

received.

The I2C embedded inside the ISM330DLC behaves like a slave device and the following

protocol must be adhered to. After the start condition (ST) a slave address is sent, once a

slave acknowledge (SAK) has been returned, an 8-bit sub-address (SUB) is transmitted.

The increment of the address is configured by the CTRL3_C (12h) (IF_INC).

The slave address is completed with a Read/Write bit. If the bit is ‘1’ (Read), a repeated

START (SR) condition must be issued after the two sub-address bytes; if the bit is ‘0’ (Write)

the master will transmit to the slave with direction unchanged. Table 14 explains how the

SAD+Read/Write bit pattern is composed, listing all the possible configurations.

Table 14. SAD+Read/Write patterns

Command

SAD[6:1]

SAD[0] = SA0

R/W

SAD+R/W

Read

110101

11010101 (D5h)

Write

110101

11010100 (D4h)

Read

110101

11010111 (D7h)

Write

110101

11010110 (D6h)

Table 15. Transfer when master is writing one byte to slave

Master

SAD + W

SUB

DATA

Slave

SAK

Table 16. Transfer when master is writing multiple bytes to slave

Master

SAD + W

SUB

DATA

Slave

SAK

Table 17. Transfer when master is receiving (reading) one byte of data from slave

Master

SAD + W

SUB

SAD + R

NMAK

Slave

SAK

DATA

Table 18. Transfer when master is receiving (reading) multiple bytes of data from slave

Master ST SAD+W

SUB

SR SAD+R

MAK

NMAK SP

Slave

SAK

DATA

DAT

DATA

ISM330DLC датащи(PDF) 40 Page - STMicroelectronics

ISM330DLC датащи(HTML) 40 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL