| поискавой системы для электроныых деталей |
|
ATtiny43U датащи(PDF) 139 Page - ATMEL Corporation |
|
|
|||||||||||||||||||||||||||||
ATtiny43U датащи(HTML) 139 Page - ATMEL Corporation |
|
139 / 182 page ![]() 139 8048B–AVR–03/09 19. Memory Programming This section describes the different methods for Programming the ATtiny43U memories. 19.1 Program And Data Memory Lock Bits The ATtiny43U provides two Lock bits which can be left unprogrammed (“1”) or can be pro- grammed (“0”) to obtain the additional security listed in Table 19-2 on page 139. The Lock bits can only be erased to “1” with the Chip Erase command. The device has no separate boot loader section. The SPM instruction is enabled for the whole Flash, if the SELFPROGEN fuse is programmed (“0”), otherwise it is disabled. Program memory can be read out via the debugWIRE interface when the DWEN fuse is pro- grammed, even if lock bits are set. Thus, when lock bit security is required, debugWIRE should always be disabled by clearing the DWEN fuse. Note: 1. “1” means unprogrammed, “0” means programmed Notes: 1. Program fuse bits before programming LB1 and LB2. 2. “1” means unprogrammed, “0” means programmed Lock bits can also be read by device firmware. See section “Reading the Fuse and Lock Bits from Software” on page 135. Table 19-1. Lock Bit Byte (1) Lock Bit Byte Bit No Description Default Value 7 – 1 (unprogrammed) 6 – 1 (unprogrammed) 5 – 1 (unprogrammed) 4 – 1 (unprogrammed) 3 – 1 (unprogrammed) 2 – 1 (unprogrammed) LB2 1 Lock bit 1 (unprogrammed) LB1 0 Lock bit 1 (unprogrammed) Table 19-2. Lock Bit Protection Modes. Memory Lock Bits (1) (2) Protection Type LB Mode LB2 LB1 1 1 1 No memory lock features enabled. 21 0 Further programming of the Flash and EEPROM is disabled in High-voltage and Serial Programming mode. The Fuse bits are locked in both Serial and High-voltage Programming mode. (1) debugWire is disabled. 30 0 Further programming and verification of the Flash and EEPROM is disabled in High-voltage and Serial Programming mode. The Fuse bits are locked in both Serial and High-voltage Programming mode. (1) debugWire is disabled. |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |