ATtiny43U datasheet(112/182 Pages) ATMEL

112 / 182 page

112

8048B–AVR–03/09

ATtiny43U

15. Analog Comparator

The Analog Comparator compares the input values on the positive pin AIN0 and negative pin

AIN1. When the voltage on the positive pin AIN0 is higher than the voltage on the negative pin

AIN1, the Analog Comparator output, ACO, is set. The comparator can trigger a separate inter-

rupt, exclusive to the Analog Comparator. The user can select Interrupt triggering on comparator

output rise, fall or toggle. A block diagram of the comparator and its surrounding logic is shown

in Figure 15-1 on page 112.

Figure 15-1. Analog Comparator Block Diagram

Notes:

1. See Table 15-1 on page 113.

See Figure 1-1 on page 2 and Table 11-3 on page 70 for Analog Comparator pin placement.

The ADC Power Reduction bit, PRADC, must be disabled in order to use the ADC input multi-

plexer. This is done by clearing the PRADC bit in the Power Reduction Register, PRR. See

“PRR – Power Reduction Register” on page 35 for more details.

15.1

Analog Comparator Multiplexed Input

It is possible to select any of the ADC[3:0] pins to replace the negative input to the Analog Com-

parator. The ADC multiplexer is used to select this input, and consequently, the ADC must be

switched off to utilize this feature. If the Analog Comparator Multiplexer Enable bit (ACME in

ADCSRB) is set and the ADC is switched off (ADEN in ADCSRA is zero), MUX[1:0] in ADMUX

select the input pin to replace the negative input to the Analog Comparator, as shown in Table

15-1. If ACME is cleared or ADEN is set, AIN1 is applied to the negative input to the Analog

Comparator.

ACBG

BANDGAP

REFERENCE

ADC MULTIPLEXER

OUTPUT

ACME

ADEN

(1)

ATtiny43U датащи(PDF) 112 Page - ATMEL Corporation