ATtiny43U datasheet(106/182 Pages) ATMEL

106 / 182 page

106

8048B–AVR–03/09

ATtiny43U

detects the start condition and sets the USISIF Flag. The flag can generate an interrupt

if necessary.

In addition, the start detector will hold the SCL line low after the master has forced a

negative edge on this line (B). This allows the slave to wake up from sleep or complete

other tasks before setting up the USI Data Register to receive the address. This is done

by clearing the start condition flag and resetting the counter.

The master set the first bit to be transferred and releases the SCL line (C). The slave

samples the data and shifts it into the USI Data Register at the positive edge of the SCL

clock.

After eight bits containing slave address and data direction (read or write) have been

transferred, the slave counter overflows and the SCL line is forced low (D). If the slave

is not the one the master has addressed, it releases the SCL line and waits for a new

start condition.

When the slave is addressed, it holds the SDA line low during the acknowledgment

cycle before holding the SCL line low again (i.e., the USI Counter Register must be set

to 14 before releasing SCL at (D)). Depending on the R/W bit the master or slave

enables its output. If the bit is set, a master read operation is in progress (i.e., the slave

drives the SDA line) The slave can hold the SCL line low after the acknowledge (E).

Multiple bytes can now be transmitted, all in same direction, until a stop condition is

given by the master (F), or a new start condition is given.

If the slave is not able to receive more data it does not acknowledge the data byte it has last

received. When the master does a read operation it must terminate the operation by forcing the

acknowledge bit low after the last byte transmitted.

14.3.5

Start Condition Detector

The start condition detector is shown in Figure 14-6. The SDA line is delayed (in the range of 50

to 300 ns) to ensure valid sampling of the SCL line. The start condition detector is only enabled

in two-wire mode.

Figure 14-6. Start Condition Detector, Logic Diagram

The start condition detector works asynchronously and can therefore wake up the processor

from power-down sleep mode. However, the protocol used might have restrictions on the SCL

hold time. Therefore, when using this feature the oscillator start-up time (set by CKSEL fuses,

see “Clock Sources” on page 24) must also be taken into consideration. Refer to the description

of the USISIF bit on page 112 for further details.

SDA

SCL

Write( USISIF)

CLOCK

HOLD

USISIF

CLR

ATtiny43U датащи(PDF) 106 Page - ATMEL Corporation

ATtiny43U датащи(HTML) 106 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL