TMS320VC5421 datasheet(49/88 Pages) TI

49 / 88 page

TMS320VC5421

DIGITAL SIGNAL PROCESSOR

SPRS098 – DECEMBER 1999

POST OFFICE BOX 1443

• HOUSTON, TEXAS 77251–1443

IDLE3 power-down mode

The IDLE1 and IDLE2 power-down modes operate as described in the

TMS320C54x DSP Reference Set,

Volume 1: CPU and Peripherals (literature number SPRU131). The IDLE3 mode is special in that the clocking

circuitry is shut off to conserve power. The ’5421 cannot enter an IDLE3 mode unless both subsystems execute

an IDLE3 instruction. The power-reduced benefits of IDLE3 cannot be realized until both subsystems enter the

IDLE3 state and the internal clocks are automatically shut off. The order in which subsystems enter IDLE3 does

not matter.

emulating the ’5421 device

The ’5421 is a single device, but actually consists of two independent subboundary systems that contain

device by modifying the board.cfg file. The board.cfg file is an ASCII file that can be modified with most editors.

This provides the emulator with a description of the JTAG chain. The board.cfg file must identify two processors

when using the ’5421. The file contents would look something like this:

“CPU_B” TI320C5xx

“CPU_A” TI320C5xx

Use the compose program to make this file into a binary file (board.dat), readable by the emulation tools. Place

the board.dat file in the directory that contains the emulator software.

The subsystems are serially connected together internally. Emulation information is serially transmitted into the

device using TDI. The device responds with serial scan information transmitted out the TDO pin.

TMS320VC5421 датащи(PDF) 49 Page - Texas Instruments