RM0319 datasheet(280/368 Pages) STMICROELECTRONICS

280 / 368 page

LCD display controller (CLCD)

RM0319

280/368

Doc ID 022640 Rev 3

24.4.8

Panel clock generator

The output of the panel clock generator block is the panel clock. This is a divided down

version of CLCDCLK. It can be programmed in the range CLCDCLK/2 to CLCDCLK/33 to

match the bpp data rate of the LCD panel.

24.4.9

Timing controller

The primary function of the timing controller block is to generate the horizontal and vertical

timing panel signals. It also provides panel bias/enable signal. These timings are all register

programmable through the AMBA AHB slave interface.

24.4.10

Interrupt generation

The CLCD provides four individually maskable interrupts and a single combined interrupt.

The single combined interrupt is asserted if any of the combined interrupts are asserted and

unmasked. The Interrupts are generated for the following events:

●

Master bus error

●

Vertical compare

●

LCD next base address update

●

FIFO underflow

See also: Section 24.6: Interrupts.

Master bus error interrupt

The master bus error interrupt is asserted when an ERROR response is received by the

master interface during a transaction with a slave. When such an error is encountered, the

master interface enters an error state and remains in this state until clearance of the error

has been signaled to it.

Vertical compare interrupt

The vertical compare interrupt asserts when one of four vertical display regions, selected

using the LCD Control Register, is reached.

●

vertical synchronization

●

back porch

●

active video

●

front porch

LCD Next base address update interrupt

The LCD next base address update interrupt asserts when either the LCDUPBASE or

LCDLPBASE values have been transferred to the LCDUPCURR or LCDLPCURR

incrementers respectively. This signals to the system that it is safe to update the

LCDUPBASE or the LCDLPBASE Registers with new frame base addresses if required.

FIFO underflow interrupt

The FIFO underflow interrupt asserts when internal data is requested from an empty DMA

FIFO. Internally, individual upper and lower panel DMA FIFO underflow interrupt signals are

generated and CLCDFUFINTR is the single combined version of these.

RM0319 датащи(PDF) 280 Page - STMicroelectronics

RM0319 датащи(HTML) 280 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL