MPC8313E datasheet(38/92 Pages) FREESCALE

38 / 92 page

MPC8313E PowerQUICC™ II Pro Processor Hardware Specifications, Rev. 1

Freescale Semiconductor

Local Bus

Figure 21 provides the AC test load for the local bus.

Figure 21. Local Bus AC Test Load

Local bus clock to output valid

tLBKHOV

—3

Local bus clock to output high impedance for LAD

tLBKHOZ

—4

Notes:

1. The symbols used for timing specifications herein follow the pattern of t(First two letters of functional block)(signal)(state) (reference)(state)

for inputs and t(First two letters of functional block)(reference)(state)(signal)(state) for outputs. For example, tLBIXKH1 symbolizes local

bus timing (LB) for the input (I) to go invalid (X) with respect to the time the tLBK clock reference (K) goes high (H), in this

case for clock one(1).

2. All timings are in reference to falling edge of LCLK0 (for all outputs and for LGTA and LUPWAIT inputs) or rising edge of

LCLK0 (for all other inputs).

3. All signals are measured from NVDD/2 of the rising/falling edge of LCLK0 to 0.4 × NVDD of the signal in question for 3.3-V

signaling levels.

4. Input timings are measured at the pin.

5.tLBOTOT1 and tLALETOT1 should be used when RCWH[LALE] is not set and the load on LALE output pin is at least 10pF less

than the load on LAD output pins.

6.tLBOTOT2 and tLALETOT2 should be used when RCWH[LALE] is set and the load on LALE output pin is at least 10pF less than

the load on LAD output pins.

7.tLBOTOT3 and tLALETOT3 should be used when RCWH[LALE] is set and the load on LALE output pin equals to the load on LAD

output pins.

8. For purposes of active/float timing measurements, the Hi-Z or off state is defined to be when the total current delivered

through the component pin is less than or equal to the leakage current specification.

Table 43. Local Bus General Timing Parameters (continued)

Parameter

Symbol 1

Min

Max

Unit

Notes

Output

Z0 = 50 Ω

NVDD/2

RL = 50 Ω

MPC8313E датащи(PDF) 38 Page - Freescale Semiconductor, Inc