| поискавой системы для электроныых деталей |
|
STM32WB50CG датащи(PDF) 92 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
STM32WB50CG датащи(HTML) 92 Page - STMicroelectronics |
|
92 / 119 page ![]() Electrical characteristics STM32WB50CG STM32WB30CE 92/119 DS13047 Rev 5 All I/Os are CMOS- and TTL-compliant (no software configuration required). Their characteristics cover more than the strict CMOS-technology or TTL parameters, as shown in Figure 20 . Figure 20. I/O input characteristics Output driving current The GPIOs (general purpose input/outputs) can sink or source up to ±8 mA, and sink or source up to ± 20 mA (with a relaxed VOL / VOH). In the user application, the number of I/O pins that can drive current must be limited to respect the absolute maximum rating specified in Section 6.2. The sum of the currents sourced by all the I/Os on VDD, plus the maximum consumption of the MCU sourced on VDD, cannot exceed the absolute maximum rating ΣIVDD (see Table 16: Voltage characteristics). The sum of the currents sunk by all the I/Os on VSS, plus the maximum consumption of the MCU sunk on VSS, cannot exceed the absolute maximum rating ΣIVSS (see Table 16: Voltage characteristics). Output voltage levels Unless otherwise specified, the parameters given in the table below are derived from tests performed under the ambient temperature and supply voltage conditions summarized in Table 20: General operating conditions. All I/Os are CMOS- and TTL-compliant (FT or TT unless otherwise specified). 7. To sustain a voltage higher than Min(VDD, VDDA) + 0.3 V, the internal pull-up and pull-down resistors must be disabled. All FT_xx IO except FT_lu, FT_u and PC3. 8. Pull-up and pull-down resistors are designed with a true resistance in series with a switchable PMOS/NMOS, whose contribution to the series resistance is minimal (~10%). MSv63025V1 2 2.5 3 3.5 Vil-Vih (all IO except BOOT0) cmos vil spec 30% cmos vih spec 70% ttl vil spec ttl ttl vih spec ttl datasheet Vil_rule datasheet Vih_rule TTL requirement Vih min = 2V TTL requirement Vil min = 0.8V 0.5 1.5 2.5 0 1 2 3 |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |