IMX6SDLCEC datasheet(82/169 Pages) NXP

82 / 169 page

i.MX 6Solo/6DualLite Applications Processors for Consumer Products, Rev. 9, 11/2018

NXP Semiconductors

Electrical Characteristics

4.11.5

Ethernet Controller (ENET) AC Electrical Specifications

The following timing specs are defined at the chip I/O pin and must be translated appropriately to arrive

at timing specs/constraints for the physical interface.

4.11.5.1

ENET MII Mode Timing

This subsection describes MII receive, transmit, asynchronous inputs, and serial management signal

timings.

4.11.5.1.1

MII Receive Signal Timing (ENET_RX_DATA3,2,1,0, ENET_RX_EN,

ENET_RX_ER, and ENET_RX_CLK)

The receiver functions correctly up to an ENET_RX_CLK maximum frequency of 25 MHz + 1%. There

is no minimum frequency requirement. Additionally, the processor clock frequency must exceed twice the

ENET_RX_CLK frequency.

Figure 43 shows MII receive signal timings. Table 55 describes the timing parameters (M1–M4) shown in

the figure.

Figure 43. MII Receive Signal Timing Diagram

1 ENET_RX_EN, ENET_RX_CLK, and ENET0_RXD0 have the same timing in 10 Mbps 7-wire interface mode.

Table 55. MII Receive Signal Timing

Characteristic1

Min

Max

Unit

ENET_RX_DATA3,2,1,0, ENET_RX_EN, ENET_RX_ER to

ENET_RX_CLK setup

5—

ENET_RX_CLK to ENET_RX_DATA3,2,1,0, ENET_RX_EN,

ENET_RX_ER hold

5—

ENET_RX_CLK pulse width high

35%

65%

ENET_RX_CLK period

ENET_RX_CLK pulse width low

35%

65%

ENET_RX_CLK period

ENET_RX_CLK (input)

ENET_RX_DATA3,2,1,0

ENET_RX_ER

ENET_RX_EN

(inputs)

IMX6SDLCEC датащи(PDF) 82 Page - NXP Semiconductors

IMX6SDLCEC датащи(HTML) 82 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL