PC87413 datasheet(243/257 Pages) NSC

243 / 257 page

11.0 Device Characteristics (Continued)

Revision 1.2

243

www.national.com

11.5.4

LPC Interface Timing

The AC characteristics of the LPC Interface meet the PCI Local Bus Specification (Rev 2.2 December 18, 1998) for 3.3V

DC signaling.

LCLK and LRESET

Symbol

Parameter

Min

Max

Units

tCYC

1. The PCI may have any clock frequency between nominal DC and 33 MHz. Device operational

parameters at frequencies under 16 MHz are guaranteed by design rather than by testing. The

clock frequency may be changed at any time during the operation of the system as long as the

clock edges remain “clean” (monotonic) and the minimum cycle high and low times are not vio-

lated. The clock may only be stopped in a low state.

LCLK Cycle Time

tHIGH

LCLK High Time2

2. Not tested. Guaranteed by characterization.

tLOW

LCLK Low Time2

LCLK Slew Rate2,3

3. Rise and fall times are speciﬁed in terms of the edge rate measured in V/ns. This slew rate

must be met across the minimum peak-to-peak portion of the clock wavering (0.2 VDD to 0.6

VDD) as shown below.

V/ns

LRESET Slew Rate2,4

4. The minimum LRESET slew rate applies only to the rising (de-assertion) edge of the reset sig-

nal and ensures that system noise cannot make an otherwise monotonic signal appear to

bounce in the switching range.

mV/ns

tHIGH

tLOW

tCYC

0.6 VDD

0.2 VDD

0.5 VDD

0.4 VDD

0.3 VDD

0.4 VDD p-to-p

(minimum)

VDD = 3.3V ±10%

PC87413 датащи(PDF) 243 Page - National Semiconductor (TI)

PC87413 датащи(HTML) 243 Page - National Semiconductor (TI)

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL