OR3LP26B datasheet(72/184 Pages) AGERE

72 / 184 page

ORCA OR3LP26B FPSC

Data Sheet

Embedded Master/Target PCI Interface

March 2000

Lucent Technologies Inc.

PCI Bus Core Detailed Description Quad Port (continued)

Table 23. Embedded Core/FPGA Interface Signals (continued)

Symbol

I/O

Description

mr_aemptyn

Master Read Data FIFO Almost Empty. This active-low signal indicates that

only four more data locations are available to be read from the Master read data

FIFOs of the PCI core.

This signal is synchronous to fclk.

mr_fulln

Master Read Data FIFO Full Flag. This active-low signal indicates that the

Master read data FIFO is full. Refer to Master read description on signal usage.

This signal is synchronous to pciclk.

fpga_mstopburstn

Stop Burst Reads. This active-low signal is used by the FPGA Master to termi-

nate burst reads before completion. When asserted, it must stay asserted for a

minimum of two pciclk periods. When asserted, fpga_mstopburstn must stay

asserted until ma_fulln goes inactive (high).

This signal must be synchronous to pciclk.

mrlastcycn

Master Read Last Data Cycle. This active-low signal is asserted to indicate

that the accompanying Master read data is the final data for this operation.

When more than one cycle is required to transfer a complete data word, this

signal is only valid on the last cycle (1 fclk period).

This signal is synchronous to fclk.

Target General Signals

disctimerexpn

Discard Timer Expired. This active-low signal, when asserted, indicates that

the discard timer has expired and the core will now treat the retried delayed

transaction as a new transaction. The discard timer is a 15-bit counter which

starts its count when a delayed transaction is started.

This signal is synchronous to fclk.

fpga_tabort

Target Abort. This active-high signal is asserted by the FPGA Target applica-

tion to abort all future PCI cycles. Once asserted, this signal needs to remain

asserted for a minimum of two pciclk cycles.

This signal must be synchronous to pciclk.

fpga_tretryn

Assert Retry. This active-low signal is asserted by an FPGA Target to the PCI

core to send a retry to the PCI bus. Once asserted, this signal needs to remain

asserted for a minimum of two pciclk cycles.

This signal must be synchronous to pciclk.

deltrn

Target Delayed Transaction. Used for Target I/O write (page 102) and Target

read operations (page 111). Target memory writes are always posted. Once

asserted, this signal needs to remain asserted for a minimum of two pciclk

cycles.

This signal must be synchronous to pciclk.

tcfgshiftenn

pci_tcfg_stat

tcfgshiftenn is an active-low signal that determines the data that is output by

the PCI core onto signal pci_tcfg_stat:

tcfgshiftenn = 1:

pci_tcfg_stat = wired-OR of all bits below, after being

masked by FPGA configuration RAM bits;

tcfgshiftenn = 0:

pci_tcfg_stat = each bit below, one at a time on suc-

cessive pciclk rising edges (unmasked), reset when

tcfgshiftenn = 1;

Status bits:

Target abort signaled, system error signaled,

and parity error detected.

Both signals are synchronous to fclk.

OR3LP26B датащи(PDF) 72 Page - Agere Systems

OR3LP26B датащи(HTML) 72 Page - Agere Systems

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL