TMS320DM643 datasheet(66/160 Pages) TI

66 / 160 page

www.ti.com

5.2

Recommended Clock and Control Signal Transition Behavior

5.3

Power Supplies

5.3.1

Power-Supply Sequencing

5.3.2

Power-Supply Design Considerations

DVDD

CVDD

VSS

C6000

DSP

Schottky

Diode

I/O Supply

Core Supply

GND

5.3.3

Power-Supply Decoupling

TMS320DM643

Video/Imaging Fixed-Point Digital Signal Processor

SPRS269A – FEBRUARY 2005 – REVISED APRIL 2005

All clocks and control signals must transition between VIH and VIL (or between VIL and VIH) in a monotonic

manner.

For more information regarding TI's power management products and suggested devices to power TI

DSPs, visit www.ti.com/dsppower.

TI DSPs do not require specific power sequencing between the core supply and the I/O supply. However,

systems should be designed to ensure that neither supply is powered up for extended periods of time

(>1 second) if the other supply is below the proper operating voltage.

A dual-power supply with simultaneous sequencing can be used to eliminate the delay between core and

I/O power up. A Schottky diode can also be used to tie the core rail to the I/O rail (see Figure 5-5).

Figure 5-5. Schottky Diode Diagram

Core and I/O supply voltage regulators should be located close to the DSP (or DSP array) to minimize

inductance and resistance in the power delivery path. Additionally, when designing for high-performance

applications utilizing the C6000™ platform of DSPs, the PC board should include separate power planes

for core, I/O, and ground, all bypassed with high-quality low-ESL/ESR capacitors.

In order to properly decouple the supply planes from system noise, place as many capacitors (caps) as

possible close to the DSP. Assuming 0603 caps, the user should be able to fit a total of 60 caps, 30 for

the core supply and 30 for the I/O supply. These caps need to be close to the DSP power pins, no more

than 1.25 cm maximum distance to be effective. Physically smaller caps, such as 0402, are better

because of their lower parasitic inductance. Proper capacitance values are also important. Small bypass

caps (near 560 pF) should be closest to the power pins. Medium bypass caps (220 nF or as large as can

be obtained in a small package) should be next closest. TI recommends no less than 8 small and

8 medium caps per supply (32 total) be placed immediately next to the BGA vias, using the "interior" BGA

space and at least the corners of the "exterior".

DM643 Peripheral Information and Electrical Specifications

TMS320DM643 датащи(PDF) 66 Page - Texas Instruments

TMS320DM643 датащи(HTML) 66 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL