PIC18F242 datasheet(133/332 Pages) MICROCHIP

133 / 332 page

DS39564C-page 131

PIC18FXX2

15.3.6

SLAVE MODE

In Slave mode, the data is transmitted and received as

the external clock pulses appear on SCK. When the

last bit is latched, the SSPIF interrupt flag bit is set.

While in Slave mode, the external clock is supplied by

the external clock source on the SCK pin. This external

clock must meet the minimum high and low times as

specified in the electrical specifications.

While in SLEEP mode, the slave can transmit/receive

data. When a byte is received, the device will wake-up

from sleep.

15.3.7

SLAVE SELECT

SYNCHRONIZATION

The SS pin allows a Synchronous Slave mode. The

SPI must be in Slave mode with SS pin control enabled

(SSPCON1<3:0> = 04h). The pin must not be driven

low for the SS pin to function as an input. The Data

Latch must be high. When the SS pin is low, transmis-

sion and reception are enabled and the SDO pin is

driven. When the SS pin goes high, the SDO pin is no

longer driven, even if in the middle of a transmitted

byte, and becomes a floating output. External pull-up/

pull-down resistors may be desirable, depending on the

application.

When the SPI module resets, the bit counter is forced

to 0. This can be done by either forcing the SS pin to a

high level or clearing the SSPEN bit.

To emulate two-wire communication, the SDO pin can

be connected to the SDI pin. When the SPI needs to

operate as a receiver the SDO pin can be configured as

an input. This disables transmissions from the SDO.

The SDI can always be left as an input (SDI function),

since it cannot create a bus conflict.

FIGURE 15-4:

SLAVE SYNCHRONIZATION WAVEFORM

Note 1: When the SPI is in Slave mode with SS

pin control enabled (SSPCON<3:0> =

0100

), the SPI module will reset if the SS

pin is set to VDD.

2: If the SPI is used in Slave mode with CKE

set, then the SS pin control must be

enabled.

SCK

(CKP = 1

SCK

(CKP = 0

Input

Sample

SDI

bit7

SDO

bit7

bit6

bit7

SSPIF

Interrupt

(SMP = 0)

CKE = 0)

(SMP = 0)

Write to

SSPBUF

SSPSR to

SSPBUF

Flag

bit0

bit7

bit0

Next Q4 cycle

after Q2

↓

PIC18F242 датащи(PDF) 133 Page - Microchip Technology

PIC18F242 датащи(HTML) 133 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL