M68ICS08GR datasheet(194/408 Pages) FREESCALE

194 / 408 page

Monitor ROM (MON)

Technical Data

MC68HC908GR8 — Rev 4.0

194

Monitor ROM (MON)

MOTOROLA

requirements and conditions, are not in effect. This is to reduce circuit

requirements when performing in-circuit programming.

NOTE:

If the reset vector is blank and monitor mode is entered, the chip will see

an additional reset cycle after the initial POR reset. Once the part has

been programmed, the traditional method of applying a voltage, VTST, to

IRQ must be used to enter monitor mode.

The COP module is disabled in monitor mode based on these

conditions:

•

If monitor mode was entered as a result of the reset vector being

blank (condition set 2 or 3), the COP is always disabled regardless

of the state of IRQ or RST.

•

If monitor mode was entered with VTST on IRQ (condition set 1),

then the COP is disabled as long as VTST is applied to either IRQ

or RST.

The second condition states that as long as VTST is maintained on the

IRQ pin after entering monitor mode, or if VTST is applied to RST after

the initial reset to get into monitor mode (when VTST was applied to IRQ),

then the COP will be disabled. In the latter situation, after VTST is applied

to the RST pin, VTST can be removed from the IRQ pin in the interest of

freeing the IRQ for normal functionality in monitor mode.

Figure 15-2 shows a simplified diagram of the monitor mode entry when

the reset vector is blank and just 1 x VDD voltage is applied to the IRQ

pin. An external oscillator of 9.8304 MHz is required for a baud rate of

9600, as the internal bus frequency is automatically set to the external

frequency divided by four.

Freescale Semiconductor, Inc.

For More Information On This Product,

Go to: www.freescale.com

M68ICS08GR датащи(PDF) 194 Page - Freescale Semiconductor, Inc