H838532H datasheet(126/508 Pages) RENESAS

номер детали	H838532H

подробное описание детали	16-Bit Single-Chip Microcomputer H8 Family / H8/300H Super Low Power Series

PDF	508 Pages

Scroll/Zoom	100%

производитель	RENESAS [Renesas Technology Corp]

домашняя страница	http://www.renesas.com

Logo

126 / 508 page

Section 5 Power-Down Modes

Rev. 1.00 May 30, 2008 Page 106 of 484

REJ09B0436-0100

5.3.2

Clearing Standby Mode

Standby mode is cleared by an interrupt (IRQ

1 or IRQ0), WKP7 to WKP0 or by input at the RES

pin.

• Clearing by interrupt

When an interrupt is requested, the system clock pulse generator starts. After the time set in

bits STS2 to STS0 in SYSCR1 has elapsed, a stable system clock signal is supplied to the

entire chip, standby mode is cleared, and interrupt exception handling starts. Operation

resumes in active (high-speed) mode if MSON = 0 in SYSCR2, or active (medium-speed)

mode if MSON = 1. Standby mode is not cleared if the I bit of CCR is set to 1 or the particular

interrupt is disabled in the interrupt enable register.

• Clearing by RES input

When the

RES pin goes low, the system clock pulse generator starts. After the pulse generator

output has stabilized, if the

RES pin is driven high, the CPU starts reset exception handling.

Since system clock signals are supplied to the entire chip as soon as the system clock pulse

generator starts functioning, the

RES pin should be kept at the low level until the pulse

generator output stabilizes.

H838532H датащи(PDF) 126 Page - Renesas Technology Corp