| поискавой системы для электроныых деталей |
|
MPF0900AMMA2ES датащи(PDF) 161 Page - NXP Semiconductors |
|
|
|||||||||||||||||||||||||||||
MPF0900AMMA2ES датащи(HTML) 161 Page - NXP Semiconductors |
|
161 / 205 page ![]() NXP Semiconductors PF09 Nine-channel power management IC with advanced system safety monitoring 3. Device goes through a Power-up sequence due to a Turn-off event or a hard reset: When the PF09 goes through a turn-off cycle due to a power off or hard reset, the turn-off FCCU interface will be reset to the default XRESET operation (FCC0 ignored, FCCU1 = XRESET input) and the MCU must request the transition to full bistable mode via the SYS_CMD[7:0] bits once it has performed its corresponding booting sequence. 14.7.3 Single-ended FCCU-level monitoring When the FCCUx is set in level monitoring mode (OTP_FCCUx_MODE[1:0] = 01), each FCCUx input pin can be used to monitor an independent single-ended error signal. The FCCUx_POL bit is used to set the polarity to detect a fault condition on each pin independently. FCCUx_POL Fault polarity detection 0 Fault when FCCUx = low 1 Fault when FCCUx = high Table 211. FCCUx fault detection in single-ended mode In single-ended level monitoring, the selection of the pullup or pulldown resistor is done based on the pin polarity, to allow a fault detection upon a pin disconnection. FCCUx_RPULL_EN FCCUx_POL Internal pull resistor 0 X FCCUx tri-stated 1 0 FCCUx pulldown 1 1 FCCUx pullup Table 212. Pull resistor selection in single-ended level monitoring 14.7.4 Single-ended FCCU PWM monitoring When the FCCUx is set in PWM monitoring mode (OTP_FCCUx_MODE[1:0] = 10), each FCCUx pin can be used to monitor an independent single-ended PWM error signal. aaa-056086 Reset phase /self-test FCCU0 EOUT[0] Normal phase Too fast Too slow Signal HIGH Error phase Signal LOW Bad dutycycle Input/high-Z Output Figure 45. FCCU single-ended PWM operation In single-ended FCCU PWM error monitoring, the FCCUx input is used to monitor a square waveform error signal. An FCCU fault condition is reported if the signal on the FCCUx pin observes any of the following conditions: PF09 All information provided in this document is subject to legal disclaimers. © 2026 NXP B.V. All rights reserved. Product data sheet Rev. 1.3 — 16 December 2025 Document feedback 161 / 205 |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |