WM8912 datasheet(64/129 Pages) CIRRUS

64 / 129 page

WM8912

Production Data

PD, Rev 4.1, February 2013

CLOCKING AND SAMPLE RATES

The internal clocks for the WM8912 are all derived from a common internal clock source, SYSCLK.

This clock is the reference for the DACs, DSP core functions, digital audio interface, DC servo control

and other internal functions.

SYSCLK can either be derived directly from MCLK, or may be generated from a Frequency Locked

Loop (FLL) using MCLK, BCLK or LRCLK as a reference. Many commonly-used audio sample rates

can be derived directly from typical MCLK frequencies; the FLL provides additional flexibility for a

wide range of MCLK frequencies. To avoid audible glitches, all clock configurations must be set up

before enabling playback. The FLL can be used to generate a free-running clock in the absence of an

external reference source; see “Frequency Locked Loop” for further details.

The WM8912 supports automatic clocking configuration. The programmable dividers associated with

the DACs, DSP core functions and DC servo are configured automatically, with values determined

from the CLK_SYS_RATE and SAMPLE_RATE fields. The user must also configure the OPCLK (if

required), the TOCLK (if required) and the Digital Audio Interface.

Oversample rates of 64fs or 128fs are supported (based on a 48kHz sample rate).

A 256kHz clock, supporting a number of internal functions, is derived from SYSCLK.

The DC servo control is clocked from SYSCLK.

A GPIO Clock, OPCLK, can be derived from SYSCLK and output on a GPIO pin to provide clocking

to other devices. This clock is enabled by OPCLK_ENA and controlled by OPCLK_DIV.

A slow clock, TOCLK, is used to de-bounce the button/accessory detect inputs, and to set the timeout

period for volume updates when zero-cross detect is used. This clock is enabled by TOCLK_ENA and

controlled by TOCLK_RATE, TOCLK_RATE_X4 and TOCLK_RATE_DIV16.

In master mode, BCLK is derived from SYSCLK via a programmable divider set by BCLK_DIV. In

master mode, the LRCLK is derived from BCLK via a programmable divider LRCLK_RATE. The

LRCLK can be derived from an internal or external BCLK source, allowing mixed master/slave

operation.

The control registers associated with Clocking and Sample Rates are shown in Table 39 to Table 43.

The overall clocking scheme for the WM8912 is illustrated in Figure 44.

WM8912 датащи(PDF) 64 Page - Cirrus Logic