SC16IS752IPW datasheet(35/59 Pages) NXP

35 / 59 page

SC16IS752_SC16IS762_7

Product data sheet

Rev. 07 — 19 May 2008

35 of 59

NXP Semiconductors

SC16IS752/SC16IS762

Dual UART with I2C-bus/SPI interface, 64-byte FIFOs, IrDA SIR

10. I2C-bus operation

The two lines of the I2C-bus are a serial data line (SDA) and a serial clock line (SCL). Both

lines are connected to a positive supply via a pull-up resistor, and remain HIGH when the

bus is not busy. Each device is recognized by a unique address whether it is a

microcomputer, LCD driver, memory or keyboard interface and can operate as either a

transmitter or receiver, depending on the function of the device. A device generating a

message or data is a transmitter, and a device receiving the message or data is a

receiver. Obviously, a passive function like an LCD driver could only be a receiver, while a

microcontroller or a memory can both transmit and receive data.

10.1 Data transfers

One data bit is transferred during each clock pulse (see Figure 12). The data on the SDA

line must remain stable during the HIGH period of the clock pulse in order to be valid.

Changes in the data line at this time will be interpreted as control signals. A HIGH-to-LOW

transition of the data line (SDA) while the clock signal (SCL) is HIGH indicates a START

condition, and a LOW-to-HIGH transition of the SDA while SCL is HIGH deﬁnes a STOP

condition (see Figure 13). The bus is considered to be busy after the START condition and

free again at a certain time interval after the STOP condition. The START and STOP

conditions are always generated by the master.

The number of data bytes transferred between the START and STOP condition from

transmitter to receiver is not limited. Each byte, which must be eight bits long, is

transferred serially with the most signiﬁcant bit ﬁrst, and is followed by an acknowledge bit

(see Figure 14). The clock pulse related to the acknowledge bit is generated by the

master. The device that acknowledges has to pull down the SDA line during the

acknowledge clock pulse, while the transmitting device releases this pulse (see

Figure 15).

Fig 12. Bit transfer on the I2C-bus

Fig 13. START and STOP conditions

mba607

data line

stable;

data valid

change

of data

allowed

SDA

SCL

mba608

SDA

SCL

STOP condition

SDA

SCL

START condition

SC16IS752IPW датащи(PDF) 35 Page - NXP Semiconductors

SC16IS752IPW датащи(HTML) 35 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59

датащи скачать

ссылки URL