| поискавой системы для электроныых деталей |
|
PC97338VLJ датащи(PDF) 100 Page - National Semiconductor (TI) |
|
|
|
|||||||||||||||||||||||||||||
PC97338VLJ датащи(HTML) 100 Page - National Semiconductor (TI) |
|
100 / 221 page ![]() 100 www.national.com 3.6.5 The INVALID Command If an invalid command (illegal opcode byte in the com- mand phase) is received by the Floppy Disk Control- ler (FDC), the controller responds with the result phase Status register 0 (ST0) in the result phase. See “Result Phase Status Register 0 (ST0)” on page 88 The controller does not generate an interrupt during this condition. Bits 7 and 6 in the MSR (see Section 3.3.6 page 80) are both set to 1, indicating to the mi- croprocessor that the controller is in the result phase and the contents of ST0 must be read. Command Phase Execution Phase None. Result Phase The system reads 80 (hex) from ST0 indicating that an invalid command was received. 3.6.6 The LOCK Command The LOCK command can be used to keep the FIFO enabled and to retain the values of some parameters after a software reset. After the command byte of the LOCK command is written, its result byte must be read before the opcode of the next command can be read. The LOCK com- mand is not executed until its result byte is read by the microprocessor. If the part is reset after the command byte of the LOCK command is written but before its result byte is read, then the LOCK command is not executed. This prevents accidental execution of the LOCK com- mand. Command Phase Bit 7 - Control Reset Effect (LOCK) This bit determines how the FIFO, THRESH, and PRETRK bits in the CONFIGURE command and, the FWR, FRD, and BST bits in the MODE com- mand are affected by a software reset. 0 -Set default values after a software reset. (De- fault) 1 - Values are unaffected by a software reset. Execution Phase Internal register is written. Result Phase Bit 4 - Control Reset Effect (LOCK) Same as bit 7 of opcode in command phase. 7654 3210 Invalid Opcodes 7654 3210 Result Phase Status Register 0 (STO) (80 hex) 7654 3210 LOCK 001 0100 7654 3210 000 LOCK 0000 |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |