PC97307 datasheet(181/218 Pages) NSC

181 / 218 page

181

Interrupt and DMA Mapping

www.national.com

12.0 Interrupt and DMA Mapping

The standard Plug and Play Configuration registers map

IRQs and DMA channels for the part. See Tables 2-8 and

2-9 starting on page 29.

12.1 IRQ MAPPING

The part allows connection of some logical devices to the 13

IRQ signals.

The polarity of an IRQ signal is controlled by bit 1 of the In-

terrupt Type registers (index 71h) of each logical device.

The same bit also controls selection of push-pull or open-

drain IRQ output. High polarity implies push-pull output.

Low polarity implies open-drain output with strong pull-up

for a short time, followed by weak pull-up.

The IRQ input signals of the KBC or mouse, and of the par-

allel port are not affected by this bit, i.e., bit 1 at index 71h

of each logical device. This bit affects only the output buffer,

not the input buffer.

Only UART1 and UART2 may map more than one logical

device to any IRQ signal. Other devices may not do so.

An IRQ signal is in TRI-STATE when any of the following

conditions is true:

• No logical device is mapped to the IRQ signal.

• The logical device mapped to the IRQ signal is inactive.

• The logical device mapped to the IRQ signal floats its

IRQ signal.

12.2 DMA MAPPING

Although the part allows some logical devices to be con-

nected to the four 8-bit DMA channels, it is illegal to map

two logical devices to the same pair of DMA signals.

A DRQ signal is in TRI-STATE and the DACK input signal

is blocked to 1 when any of the following conditions is true:

• No logical device is mapped to the DMA channel.

• The logical device mapped to the DMA channel is inac-

tive.

• The logical device mapped to the DMA channel floats its

DRQ signal.

PC97307 датащи(PDF) 181 Page - National Semiconductor (TI)