TUSB3410 datasheet(46/92 Pages) TI

46 / 92 page

6–6

The DMA transfers data from the UART to the X buffer. When a block of 64 bytes is transferred, the DMA

updates the byte count and sets NAK = 0 in IEDB (indicating to the UBM that the X buffer is ready to be

transferred to host). The UBM starts X-buffer transfer to host using the byte-count value in IEDB and toggles

the X/Y bit. The DMA continues transferring data from a device to Y-buffer. At the end of the block transfer,

the DMA updates the byte count and sets NAK = 0 in IEDB (indicating to the UBM that the Y-buffer is ready

to be transferred to host). The DMA continues the transfer from the device to host, alternating between

X-and Y-buffers without MCU intervention.

Transfer termination: As mentioned, the DMA/UBM continues the data transfer, alternating between the X-

and Y-buffers. Termination of the transfer can happen under the following conditions:

•

Stop Transfer: The host notifies the MCU (via control-end-point) to stop the transfer. Under this

condition, the MCU sets EN = 0 in the DMACDR register.

•

Partial Packet: The device receiver has no data to be transferred to host. Under this condition, the

byte-count value is less than 64 when the transaction timer time-out occurs. When the DMA detects this

condition, it sets TXFT = 1 and OVRUN = 0, updates the byte count and NAK bit (partial packet) in the

IEDB, and interrupts the MCU. UBM transfers the partial packet to host.

•

Buffer Overrun: The host is busy, X- and Y-buffers are full (X NAK = 0 and Y–NAK = 0) and the DMA

cannot write to these buffers. The transaction time-out stops the DMA transfer, the DMA sets TXFT = 1

and OVRUN = 1, and interrupts the MCU.

•

UART Error Condition: When receiving from a UART, a receiver-error condition stops the DMA and

sets TXFT = 1 and OVRUN = 0, but the EN bit remains set at 1. Therefore, the DMA does not interrupt

the MCU. However, the UART generates a status interrupt, notifying the MCU that an error condition

has occurred.

6.2.2

OUT Transaction (Host to TUSB3410)

The MCU initializes the OEDB (64-byte packet, and double buffering is used) and the following DMA

registers:

•

DMACSR: Defines the transaction time-out value.

•

DMACDR: Defines the OEDB being used, and the DMA mode of operation (continuous mode). Once

the EN bit is set to 1 in this register, the transfer starts.

The UBM transfers data from host to X-buffer. When a block of 64 bytes is transferred, the UBM updates

the byte count and sets NAK = 1 in OEDB (indicating to DMA that the X-buffer is ready to be transferred

to the UART). The DMA starts X-buffer transfer using the byte-count value in OEDB. The UBM continues

transferring data from host to Y-buffer. At the end of the block transfer, the UBM updates the byte count and

sets NAK = 1 in OEDB (indicating to DMA that the Y-buffer is ready to be transferred to device). The DMA

continues the transfer from the X-/Y-buffers to the device, alternating between X- and Y-buffers without MCU

intervention.

Transfer termination: The DMA/UBM continues the data transfer alternating between X- and Y-buffers. The

termination of the transfer can happen under the following conditions:

•

Stop Transfer: The host notifies the MCU (via control-end point) to stop the transfer. Under this

condition, the MCU sets EN = 0 in the DMACDR register.

•

Partial-Packet: UBM receives a partial packet from host. Under this condition, the byte-count value is

less than 64 and the transaction timer does not time-out. When the DMA detects this condition, it

transfers the partial packet to the device, sets TXFT = 0 and PPKT = 1, updates NAK = 0 in OEDB, and

interrupts the MCU.

•

Time-out: The device is busy, X- and Y-buffers are full (X-NAK = 1 and Y-NAK = 1) and the UBM cannot

write to these buffers. Under this condition the transaction timer time-out stops the DMA transfer, sets

TXFT = 1 and OVRUN = 0, and interrupts the MCU.

TUSB3410 датащи(PDF) 46 Page - Texas Instruments

TUSB3410 датащи(HTML) 46 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92

датащи скачать

ссылки URL