SH7014 datasheet(103/754 Pages) RENESAS

103 / 754 page

5. Exception Processing

Rev.5.00 Sep. 27, 2007 Page 69 of 716

REJ09B0398-0500

5.6

When Exception Sources Are Not Accepted

When an address error or interrupt is generated after a delayed branch instruction or interrupt-

disabled instruction, it is sometimes not accepted immediately but stored instead, as shown in

table 5.9. When this happens, it will be accepted when an instruction that can accept the exception

is decoded.

Table 5.9

Generation of Exception Sources Immediately after a Delayed Branch

Instruction or Interrupt-Disabled Instruction

Exception Source

Point of Occurrence

Address Error

Interrupt

Immediately after a delayed branch instruction*1

Not accepted

Immediately after an interrupt-disabled instruction*2

Accepted

Not accepted

Notes: 1. Delayed branch instructions: JMP, JSR, BRA, BSR, RTS, RTE, BF/S, BT/S, BSRF,

BRAF

2. Interrupt-disabled instructions: LDC, LDC.L, STC, STC.L, LDS, LDS.L, STS, STS.L

5.6.1

Immediately after a Delayed Branch Instruction

When an instruction placed immediately after a delayed branch instruction (delay slot) is decoded,

neither address errors nor interrupts are accepted. The delayed branch instruction and the

instruction located immediately after it (delay slot) are always executed consecutively, so no

exception processing occurs during this period.

5.6.2

Immediately after an Interrupt-Disabled Instruction

When an instruction immediately following an interrupt-disabled instruction is decoded, interrupts

are not accepted. Address errors are accepted.

SH7014 датащи(PDF) 103 Page - Renesas Technology Corp