STM32H533CE datasheet(189/231 Pages) STMICROELECTRONICS

189 / 231 page

DS14539 Rev 1

189/231

STM32H533xx

Electrical characteristics

200

I3C interface characteristics

The I3C interface meets the timings requirements of the MIPI® I3C specification v1.1.

The I3C peripheral supports:

•

I3C SDR-only as controller

•

I3C SDR-only as target

•

I3C SCL bus clock frequency up to 12.5 MHz

The parameters given in Table 108 are obtained with the following configuration:

•

Output speed is set to OSPEEDRy[1:0] = 10

•

I/O compensation cell activated

•

HSLV activated when VDD ≤ 2.7 V

•

VOS level set to VOS 0

The timings are in line with MIPI specification, except for the ones given in Table 108 and

Table 109. For tSU_OD and tSU_PP this can be mitigated by increasing the corresponding

SCL low duration in the I3C_TIMINGR0 register. For tSCO this can be mitigated by enabling

and adjusting the clock stall time both on the address ACK phase and on the data read Tbit

phase in the I3C_TIMINGR2 register. This can also be mitigated by increasing the SCL low

duration in the I3C_TIMINGR0 register. For further details refer to AN5879.

SPI interface characteristics

Unless otherwise specified, the parameters given in Table 110 are derived from tests

performed under the ambient temperature, fPCLKx frequency and VDD supply voltage

conditions summarized in Table 20, with the following configuration:

•

Output speed is set to OSPEEDRy[1:0] = 11

•

Capacitive load CL = 30 pF

•

Measurement points are done at CMOS levels: 0.5 VDD

•

I/O compensation cell activated

•

HSLV activated when VDD ≤ 2.7 V

Table 108. I3C open-drain measured timing

Symbol

Parameter

Conditions

I3C open drain mode

(specification)

Timing

measurements

Unit

Min

Max

tSU_OD

SDA data setup time

during open drain mode

Controller

1.71 V < VDD < 3.6 V

16.5

Table 109. I3C push-pull measured timing

Symbol

Parameter

Conditions

I3C open drain mode

(specification)

Timing

measurements

Unit

Min

Max

tSU_PP

SDA signal data setup in

push-pull mode

Controller

1.71 V < VDD < 3.6 V

STM32H533CE датащи(PDF) 189 Page - STMicroelectronics

STM32H533CE датащи(HTML) 189 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL