AD9516-2SLASHPCBZ datasheet(80/84 Pages) AD

80 / 84 page

AD9516-2

Rev. 0 | Page 80 of 84

CMOS CLOCK DISTRIBUTION

The AD9516 provides four clock outputs (OUT6 to OUT9)

that are selectable as either CMOS or LVDS level outputs.

When selected as CMOS, each output becomes a pair of CMOS

outputs, each of which can be individually turned on or off and

set as noninverting or inverting. These outputs are 3.3 V CMOS

compatible.

Whenever single-ended CMOS clocking is used, some of the

following general guidelines should be used.

Point-to-point nets should be designed such that a driver has

only one receiver on the net, if possible. This allows for simple

termination schemes and minimizes ringing due to possible

mismatched impedances on the net. Series termination at the

source is generally required to provide transmission line

matching and/or to reduce current transients at the driver.

The value of the resistor is dependent on the board design and

timing requirements (typically 10 Ω to 100 Ω is used). CMOS

outputs are also limited in terms of the capacitive load or trace

length that they can drive. Typically, trace lengths less than

3 inches are recommended to preserve signal rise/fall times and

preserve signal integrity.

CMOS

10Ω

60.4Ω

(1.0 INCH)

MICROSTRIP

Figure 72. Series Termination of CMOS Output

Termination at the far end of the PCB trace is a second option.

The CMOS outputs of the AD9516 do not supply enough

current to provide a full voltage swing with a low impedance,

resistive, far-end termination, as shown in Figure 73. The far-

end termination network should match the PCB trace impedance

and provide the desired switching point. The reduced signal

swing may still meet receiver input requirements in some

applications. This can be useful when driving long trace

lengths on less critical nets.

CMOS

10Ω

50Ω

100Ω

Figure 73. CMOS Output with Far-End Termination

Because of the limitations of single-ended CMOS clocking,

consider using differential outputs when driving high speed

signals over long traces. The AD9516 offers both LVPECL and

LVDS outputs that are better suited for driving long traces

where the inherent noise immunity of differential signaling

provides superior performance for clocking converters.

AD9516-2/PCBZ датащи(PDF) 80 Page - Analog Devices

AD9516-2/PCBZ датащи(HTML) 80 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84

датащи скачать

ссылки URL