SPC56EL70L3 datasheet(126/128 Pages) STMICROELECTRONICS

126 / 128 page

Revision history

SPC56EL70L3, SPC56EL70L5,PC564L70L3, SPC564L70L5

126/128

DocID023953 Rev 5

Revision history

Table 42. Revision history

Date

Revision

Changes

23-Nov-2012

Initial release.

03-Sep-2013

Revision 2 changes:

– Replaced IEC with ISO26262 in Section 1.1: Document overview

– Updated Section 3.15.1: Input Impedance and ADC Accuracy -

replaced fC by fS

– Table 6: System pins - added footnote to RESET pin about weak

pull down

– Updated Equation 11

– Updated Table 26: Flash memory program and erase electrical

specifications

- Removed “Factory Average” column and updated

the values in “Initial Max” column from rows 3 to 7

– Updated Figure 41: Commercial product code structure and added

a note to the figure

– Updated the following in Table 8: Absolute maximum ratings:

Updated the “Max” column values

Updated the table footnotes

– Updated the following in Table 9: Recommended operating

conditions (3.3 V)

Added table footnote “VDD_HV_ADRx must always be applied and

should be stable before LBIST starts. If this supply is not above its

absolute minimum level, LBIST operations can fail”

Maximum values of VDD_HV_REG, VDD_HV_IOx, VDD_HV_FLA, VDD_HV_OSC,

VDD_HV_ADV changed from “3.6” to “3.63”

Min and max value of VDD_HV_ADR0 and VDD_HV_ADR1 changed

from “4.5 to 5.5 or 3.0 to 3.6” to “4.5 to 5.5 or 3.0 to 3.63”

– Updated the following values in Table 18: Voltage regulator

electrical specifications

For “Combined ESR of external capacitor” min value is updated to

“1” and max value is updated to “100”

For “Main High Voltage Power - Low Voltage Detection, upper

threshold” max value is updated as “2.93”

Added row “Digital supply low voltage detector lower threshold” for

condition “After a destructive reset initialization phase completion”

Added row “Digital supply low voltage detector upper threshold” for

condition “Before a destructive reset initialization phase”

For row “Digital supply high voltage detector upper threshold”,

condition “After a destructive reset initialization phase completion” min

value is changed from “1.38” to “1.39”

SPC56EL70L3 датащи(PDF) 126 Page - STMicroelectronics

SPC56EL70L3 датащи(HTML) 126 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL