18F8680 datasheet(33/496 Pages) MICROCHIP

33 / 496 page

 2004 Microchip Technology Inc.

DS30491C-page 31

PIC18F6585/8585/6680/8680

2.7

Effects of Sleep Mode on the

On-Chip Oscillator

When the device executes a SLEEP instruction, the on-

chip clocks and oscillator are turned off and the device

is held at the beginning of an instruction cycle (Q1

state). With the oscillator off, the OSC1 and OSC2

signals will stop oscillating. Since all the transistor

switching currents have been removed, Sleep mode

achieves the lowest current consumption of the device

(only leakage currents). Enabling any on-chip feature

that will operate during Sleep will increase the current

consumed during Sleep. The user can wake from

Sleep through external Reset, Watchdog Timer Reset,

or through an interrupt.

TABLE 2-3:

OSC1 AND OSC2 PIN STATES IN SLEEP MODE

2.8

Power-up Delays

Power-up delays are controlled by two timers so that no

external Reset circuitry is required for most applica-

tions. The delays ensure that the device is kept in

Reset until the device power supply and clock are sta-

ble. For additional information on Reset operation, see

Section 3.0 “Reset”.

The first timer is the Power-up Timer (PWRT) which

optionally provides a fixed delay of 72 ms (nominal) on

power-up only (POR and BOR). The second timer is

the Oscillator Start-up Timer (OST), intended to keep

the chip in Reset until the crystal oscillator is stable.

With the PLL enabled (HS+PLL and EC+PLL Oscillator

mode), the time-out sequence following a Power-on

Reset is different from other oscillator modes. The

time-out sequence is as follows: First, the PWRT time-

out is invoked after a POR time delay has expired.

Then, the Oscillator Start-up Timer (OST) is invoked.

However, this is still not a sufficient amount of time to

allow the PLL to lock at high frequencies. The PWRT

timer is used to provide an additional fixed 2 ms

(nominal) time-out to allow the PLL ample time to lock

to the incoming clock frequency.

OSC Mode

OSC1 Pin

OSC2 Pin

Floating, external resistor should pull high

At logic low

RCIO

Floating, external resistor should pull high

Configured as PORTA, bit 6

ECIO

Floating

Configured as PORTA, bit 6

Floating

At logic low

LP, XT, and HS

Feedback inverter disabled at

quiescent voltage level

Feedback inverter disabled at

quiescent voltage level

Note:

See Table 3-1 in Section 3.0 “Reset”, for time-outs due to Sleep and MCLR Reset.

18F8680 датащи(PDF) 33 Page - Microchip Technology

18F8680 датащи(HTML) 33 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL