WM8945ECSSLASHR datasheet(35/169 Pages) WOLFSON

35 / 169 page

Production Data

WM8945

PD, May 2011, Rev 4.1

DF1 FILTER

The DF1 filter is part of the SE1 block. This provides a direct-form 1 standard filter, as illustrated in

Figure 16. The default coefficients give a transparent filter response.

Figure 16 Direct-Form 1 Standard Filter Structure

The DF1 response is defined by the following equations:

]

[

]

[

]

[

]

[

















The DF1 filter is enabled using the SE1_DF1_L_ENA register bit defined in Table 13. For the

derivation of the other associated registers, refer to the configuration tools supplied with the WM8945

Evaluation Kit.

The DF1 filter can be used to implement very complex response patterns, with specific phase and

gain responses at different frequencies. Typical applications of this type of filter include the

application of refinements or other user-selected filters.

RETUNE

TM FILTER

The ReTune™ filter is part of the SE2 block. This is a very advanced feature that is intended to

perform frequency linearization according to the particular needs of the application microphone,

loudspeaker or housing. The ReTune™ algorithms can provide acoustic equalisation and selective

phase (delay) control of specific frequency bands. The ReTune™ filters are enabled using the

SE2_RETUNE_L_ENA register bit defined in Table 14.

For the derivation of the other ReTune™ configuration parameters, the Wolfson WISCE™ software

must be used to analyse the requirements of the application. (Refer to WISCE for further information.)

If desired, one or more sets of register coefficients might be derived for different operating scenarios,

and these may be recalled and written to the CODEC registers as required in the target application.

The ReTune™ configuration procedure involves the generation and analysis of test signals as

outlined below.

To determine the characteristics of the microphone in an application, a test signal is applied to a

loudspeaker that is in the acoustic path to the microphone. The received signal through the

application microphone is analysed and compared with the received signal from a reference

microphone in order to determine the characteristics of the application microphone.

WM8945ECS/R датащи(PDF) 35 Page - Wolfson Microelectronics plc

WM8945ECS/R датащи(HTML) 35 Page - Wolfson Microelectronics plc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL