13892 datasheet(96/161 Pages) FREESCALE

96 / 161 page

Analog Integrated Circuit Device Data

Freescale Semiconductor

13892

FUNCTIONAL DEVICE OPERATION

BATTERY INTERFACE AND CONTROL

The precharge will time-out and stop charging, in case it did not succeed in raising the battery to a high enough level: BATTON

for internal precharge, external precharge in the case of USB, and BPON for the external precharge, in case of a charger. This

is a fault condition and is flagged to the processor by the CHGFAULTI interrupt, and the CHGFAULTS[1:0] bits are set to 10.

The charging circuit will stop charging and generate a CHGCURRI interrupt after the battery is fully charged. This is detected

by the charge current dropping below the CHGCURR limit. The charger automatically restarts if the battery voltage is below

BATTCYCL. Software can bypass this cyclic mode of operation by setting the CYCLB bit. Setting the bit does not prevent

interrupts to be generated.

During charging, a charge timer is running. When expiring before the CHGCURR limit is reached, the charging will be stopped

and an interrupt generated. The charge timer can be reset before it expires by setting the self clearing CHGTMRRST bit. After

expiration, the charger needs to be restarted. Proper charge termination and restart is a relatively slow process. Therefore in both

of the previous cases, the charging will rapidly resume, in case of a sudden battery bounce. This is detected by BP dropping

below the BATTON threshold.

Out of any state and after a time-out, the charger state machine can be restarted by removing and reapplying the charger. A

software restart can also be initiated by setting the self clearing CHGRESTART bit.

The state of the charger logic is reflected by means of the CHGENS bit. This bit is therefore a 1 in all states of the charger

state machine, except when in a fault condition or when at the end of charge. In low power boot mode, the bit is not set until the

ACKLPB bit is set. This also means that the CHGENS bit is not cleared when the power limiter interacts, or when the battery

temperature is out of range. The charge LED At CHRGLED follows the state of the CHGENS bit with the exception that software

can force the LED driver on.

The detection of a serial path versus a single path is reflected through the CHRGSSS bit. A logic 1 indicates a serial path. In

cases of single path, the pin BATTFET must be left floating.

The charging circuit will stop charging, in case the die temperature of the IC exceeds the thermal protection threshold. The

state machine will be re-initiated again when the temperature drops below this threshold.

SOFTWARE CONTROLLED CHARGING

The charger can also be operated under software control. By setting CHGAUTOB = 1, full control of the charger settings is

assumed by software. The state machine will no longer determine the mode of charging. The only exceptions to this are a charger

removal, a charger over-voltage detection and excessive power dissipation in M1/M2.

For safety reasons, when a RESETB occurs, the software controlled charging mode is exited for the standalone charging

operation mode.

In the software controlled charging mode, the internal trickle charger settings can be controlled as well as the M3 operation

through FETCTRL (1 = conducting). The latter is only possible if the FETOVRD bit is set. If a sudden drop in BP occurs (BP <

BPON) while M3 is open, the charger control logic will immediately close M3 under the condition that BATT > BATTMIN.

Table 77. Charger Timer Characteristics

Parameter

Condition

Min

Typ

Max

Units

Charger Timer

120

min

Precharge Timer

External precharge 80 mA

Internal precharge 40/80 mA

270

min

External precharge 400/560 mA

min

Table 78. Charger Fault Conditions

Fault Condition

CHGFAULTS[1:0]

CHGFAULTI

Cleared or no fault condition

Not generated

Over-voltage at CHRGRAW

Rising edge

Excessive dissipation on M1/M2

Rising edge

Sudden battery drop below BATTMIN

Rising edge

Any charge time-out

Rising edge

Out of temperature

Dual edge

13892 датащи(PDF) 96 Page - Freescale Semiconductor, Inc

13892 датащи(HTML) 96 Page - Freescale Semiconductor, Inc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL