AT697F datasheet(64/155 Pages) ATMEL

номер детали	AT697F

подробное описание детали	Rad-Hard 32 bit SPARC V8 Processor

PDF	155 Pages

Scroll/Zoom	100%

производитель	ATMEL [ATMEL Corporation]

домашняя страница	http://www.atmel.com

Logo

64 / 155 page

7703C–AERO–6/09

AT697F ADVANCE INFORMATION

Debug Operations

Instruction Breakpoints

To insert instruction breakpoints, the breakpoint instruction (ta 1) should be used. This will leave

the four IU hardware breakpoints free to be used as data watchpoints. Since cache snooping is

only done on the data cache, the instruction cache must be flushed after the insertion or removal

of breakpoints. To minimize the influence on execution, it is enough to clear the corresponding

instruction cache tag (which is accesible through the DSU).

The DSU hardware breakpoints should only be used to freeze the trace buffer, and not for soft-

ware debugging since there is a 4-cycle delay from the breakpoint hit before the processor

enters the debug mode.

Single Stepping

By writing the TBC SS and reseting the TBC BN bit, the processor will resume execution for

one instruction and then automatically enter debug mode.

DSU Trap

The DSU trap register (DTR) consists in a read-only register that indicates which SPARC trap

type caused the processor to enter debug mode.

When debug mode is forced by setting the TBC BN, the trap type is 0x0B.

AT697F датащи(PDF) 64 Page - ATMEL Corporation