M16CSLASH29 datasheet(300/499 Pages) RENESAS

300 / 499 page

16. MULTI-MASTER I2C bus INTERFACE

page 276

16.7.1 Bit0: Time-Out Detection Function Enable Bit (TOE)

The TOE bit enables the time-out detection function. When the TOE bit is set to 1, time-out is detected

and the I2C bus interface interrupt request is generated when the following conditions are met.

1) the BB flag in the S10 register is set to 1 (bus busy)

2) the SCL clock stops for time-out detection period while high-level ("H") signal is maintained (see

Table 16.7

)

The internal counter measures the time-out detection time and the TOSEL bit selects between two

modes, long time and short time. When time-out is detected, set the ES0 bit to 0 (I2C bus interface

disabled) and reset the counter.

16.7.2 Bit1: Time-Out Detection Flag (TOF )

The TOF flag indicates the time-out detection. If the internal counter which measures the time-out

period overflows, the TOF flag is set to 1 and the I2C bus interface interrupt request is generated at the

same time.

16.7.3 Bit2: Time-Out Detection Period Select Bit (TOSEL)

The TOSEL bit selects time-out detection period from long time mode and short time mode. When the

TOSEL bit is set to 0, long time mode is selected. When it is set to 1, short time mode is selected,

respectively. The internal counter increments as a 16-bit counter in long time mode, while the counter

increments as a 14-bit counter in short time mode, based on the I2C system clock (VIIC) as a counter

source. Table 16.7 shows examples of time-out detection period.

Table 16.7 Examples of Time-out Detection Period

(Unit: ms)

16.7.4 Bits 3,4,5: I2C System Clock Select Bits (ICK2-4)

Bits ICK4 to ICK2, and bits ICK1 and ICK0 in the S3D0 register, and the PCLK0 bit in the PCLKR register

select the system clock (VIIC) of the I2C bus interface circuit. See Table 16.6 for the setting values.

16.7.5 Bit7: STOP Condition Detection Interrupt Request Bit (SCPIN)

The SCPIN bit monitors the stop condition detection interrupt. The SCPIN bit is set to 1 when the I2C bus

interface interrupt is generated by detecting the STOP condition. When this bit is set to 0 by program, it

becomes 0. However, no change occurs even if it is set to 1.

VIIC(MHz)

Long time mode

Short time mode

16.4

4.1

32.8

8.2

65.6

16.4

M16C/29 датащи(PDF) 300 Page - Renesas Technology Corp