 |
поискавой системы для электроныых деталей |
|
|
поискавой системы для электроныых деталей |
|
M66596FP датащи(PDF) 53 Page - Renesas Technology Corp |
|
|
|||||||||||||||||||||||||||||
M66596FP датащи(HTML) 53 Page - Renesas Technology Corp |
|
|
53 / 131 page  M66596FP/WG rev .1.00 2006.3.14 page 53 of 127 3.1.7.3 Low-power sleep state The low-power sleep state is set by setting “1” for the PCUT bit of the SYSCFG register. For information on the sequence in which settings are entered for the low-power sleep state, please refer to Chapter 3.1.8.2 , and for information on register control timing, please refer to the timing diagram noted later (Figure 3.6 Low-power control timing diagram). In the low-power sleep state, of the registers set by software, only registers other than those noted below are initialized. After returning to the normal operating state, the settings must be re-entered using software. Table 3.5 shows the registers that are not initialized when the controller is in the low-power sleep state. Table 3.5 Registers that are not initialized in the low-power sleep state Register Bit Description XTAL This is retained as system information. ATCKM This is retained as system information. HSE This is retained as system information. DCFM This is retained as system information. DMRPD This is retained as system information. DPRPU This is retained as system information. FSRPC This is retained as system information. SYSCFG USBE This is retained as system information. PINCFG LDRV The state of the output pin drive current settings is retained. DMAxCFG DREQA The polarity of the DREQ0_N pin and the DREQ1_N pin are retained. VBSE / VBINT When "VBSE=1", if there was any change to the VBUS signal in the low-power sleep state, the INT_N pin is asserted and notification is made to the CPU. INTENB0/ INTSTS0 RSME / RESM When "RSME=1", if there was any change to the USB data bus in the low-power sleep state, the INT_N pin is asserted and notification is made to the CPU. INTENB1/ INTSTS1 BCHGE / BCHG When "BCHGE=1", if there was any change to the USB data bus in the low-power sleep state, the INT_N pin is asserted and notification is made to the CPU. |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |
Russian ▼
English
Chinese
German
Japanese
Russian
Korean
Spanish
French
Italian
Portuguese
Polish
Vietnamese
Indian
Mexican
British
New Zealand
