C167CS-L datasheet(56/81 Pages) INFINEON

56 / 81 page

C167CS-4R

C167CS-L

Data Sheet

V2.2, 2001-08

Table 10

Current Limits for Port Output Drivers

Port Output Driver

Maximum Output Current

(

IOLmax, -IOHmax)

Nominal Output Current

(

IOLnom, -IOHnom)

P2.7 - P2.0

10 mA

2.5 mA

(PORT0, PORT1,

Port 4, ALE, RD, WR,

BHE, CLKOUT,

RSTOUT, RSTIN2))

-----

2.5 mA

All other outputs

-----

1.6 mA

1) An output current above |I

OXnom| may be drawn from up to three pins (P2.7-P2.0 only) at the same time.

For any group of 16 neighboring port output pins the total output current in each direction (

ΣIOL and/or Σ-IOH)

must remain below 50 mA.

2) Valid for V

OL in bidirectional reset mode only.

Power Consumption C167CS

(Operating Conditions apply)

Parameter

Symbol

Limit Values

Unit Test Condition

min.

max.

Power supply current (active)

with all peripherals active

IDD5

–

20 +

3.2

× fCPU

RSTIN =

VIL

fCPU in [MHz]

1) The supply current is a function of the operating frequency. This dependency is illustrated in Figure 10.

These parameters are tested at

VDDmax and maximum CPU clock with all outputs disconnected and all inputs

VIL or VIH.

Idle mode supply current

with all peripherals active

IIDX5

2) These values are not 100% tested but verified by means of system characterization.

–

15 +

1.4

× fCPU

RSTIN =

VIH1

fCPU in [MHz]

Idle mode supply current

with all peripherals deactivated,

PLL off, SDD factor = 32

IIDO

3)2)

3) This parameter is determined mainly by the current consumed by the oscillator (see Figure 9). This current,

however, is influenced by the external oscillator circuitry (crystal, capacitors). The values given refer to a typical

circuitry and may change in case of a not optimized external oscillator circuitry (see also application notes

AP2420: Crystal Oscillator, AP2424: Ceramic Resonator Oscillator).

–

800 +

× fOSC

µARSTIN = VIH1

fOSC in [MHz]

Sleep and Power-down mode

supply current with RTC running

IPDR

3)2)

–

800 +

× fOSC

µA

VDD = VDDmax

fOSC in [MHz]

4) This parameter is tested including leakage currents. All inputs (including pins configured as inputs) at 0 V to

0.1 V or at

VDD - 0.1 V to VDD, VREF = 0 V, all outputs (including pins configured as outputs) disconnected.

Sleep and Power-down mode

supply current with RTC disabled

IPDO

–

µA

VDD = VDDmax

C167CS-L датащи(PDF) 56 Page - Infineon Technologies AG

C167CS-L датащи(HTML) 56 Page - Infineon Technologies AG

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81

датащи скачать

ссылки URL