ADS5400

www.ti.com

SLAS611C – OCTOBER 2009 – REVISED JANUARY 2016

•

Changed Table 5, BIT 4 From: 1 To: 0 ................................................................................................................................ 32

•

Deleted note: (was not available on early samples) from SPI Register Reset in Table 5.................................................... 32

Changes from Original (October 2009) to Revision A

Page

•

Changed the FEATURES list ................................................................................................................................................. 1

•

Deleted text "Internal pull-down resistor" from the SCLK, SDIO, and SDO pins in the Pin Functions table ......................... 5

•

Changed the SDENB pin text From: "Internal pull-up resistor" To: "Internal 100k

Ω pull-up resisto" in the Pin

Functions table ....................................................................................................................................................................... 5

•

Added Note to the Pin Functions table - This pin contains an internal ~40k

Ω pull-down resistor, to ground. ....................... 5

•

Changed Abs Max, Recommended Op Conditions, and Electrical Specs values. ............................................................... 6

•

Changed the description of the ANALOG INPUT entry in the Rec Op Condition table From: Differential input range

To: Full-scale differential input range ..................................................................................................................................... 7

•

Changed the Rec Op table, VCM - TYP value From: 2.5V To AVDD5/2 ................................................................................ 7

•

Changed the description of the ANALOG INPUT entry in the Elect Char table From: Differential input range To: Full-

scale differential input range................................................................................................................................................... 7

•

Changed the Elect Char table, VCM - TYP value From: 2.5V To AVDD5/2............................................................................ 7

•

Changed the Timing Diagrams illustrations.......................................................................................................................... 13

•

Changed Figure 1 ................................................................................................................................................................. 13

•

Changed Figure 2 ................................................................................................................................................................. 14

•

Changed Figure 3 ................................................................................................................................................................. 15

•

Changed Figure 4 ................................................................................................................................................................. 16

•

Changed Figure 5 ................................................................................................................................................................. 17

•

Changed the TYPICAL CHARACTERISTICS, Conditions Note From: DVDD3 = 3.3 V, and 3.3-VPP differential clock

To: DVDD = 3.3V and 1.5 VPP differential clock ................................................................................................................... 18

•

Added subsection - Analog Input Over-Range Recovery Error............................................................................................ 24

•

Changed the Clock Inputs subsection .................................................................................................................................. 24

•

Changed the Test Patterns subsection ................................................................................................................................ 27

•

Changed the Interleaving subsection ................................................................................................................................... 28

•

Changed Table 6 BIT <7:3>, Title and description............................................................................................................... 33

•

Changed Table 7 BIT <0>, Default setting description, and BIT <7:2> description ............................................................. 33

•

Changed Table 8 BIT <0>, Default setting description ........................................................................................................ 34

•

Changed Serial Register 0x06 (Read or Write) (Table 10). Bits 4 and 5 From TBD To: 0.................................................. 36

•

Deleted Table 10 description comment from BIT <7:6> 11: (this mode is not working properly on early samples - will

be fixed) ................................................................................................................................................................................ 36

•

Changed the Power Supplies subsection............................................................................................................................. 43

•

Added Figure 40 - Was TBD ................................................................................................................................................ 43

Copyright © 2009–2016, Texas Instruments Incorporated

Submit Documentation Feedback

3

Product Folder Links: ADS5400