M25PX32-VMP6F datasheet(30/63 Pages) STMICROELECTRONICS

30 / 63 page

Instructions

M25PX32

30/63

6.5

Write Status Register (WRSR)

The Write Status Register (WRSR) instruction allows new values to be written to the Status

have been executed. After the Write Enable (WREN) instruction has been decoded and

executed, the device sets the Write Enable Latch (WEL).

The Write Status Register (WRSR) instruction is entered by driving Chip Select (S) Low,

followed by the instruction code and the data byte on Serial Data input (DQ0).

The instruction sequence is shown in Figure 12.

The Write Status Register (WRSR) instruction has no effect on b6, b1 and b0 of the Status

Chip Select (S) must be driven High after the eighth bit of the data byte has been latched in.

If not, the Write Status Register (WRSR) instruction is not executed. As soon as Chip Select

(S) is driven High, the self-timed Write Status Register cycle (whose duration is tW) is

initiated. While the Write Status Register cycle is in progress, the Status Register may still

be read to check the value of the Write In Progress (WIP) bit. The Write In Progress (WIP)

bit is 1 during the self-timed Write Status Register cycle, and is 0 when it is completed.

When the cycle is completed, the Write Enable Latch (WEL) is reset.

The Write Status Register (WRSR) instruction allows the user to change the values of the

Block Protect (BP2, BP1, BP0) bits, to define the size of the area that is to be treated as

read-only, as defined in Table 3. The Write Status Register (WRSR) instruction also allows

the user to set and reset the Status Register Write Disable (SRWD) bit in accordance with

the Write Protect (W/VPP) signal. The Status Register Write Disable (SRWD) bit and Write

Protect (W/VPP) signal allow the device to be put in the hardware protected mode (HPM).

The Write Status Register (WRSR) instruction is not executed once the hardware protected

mode (HPM) is entered.

Figure 12.

Write Status Register (WRSR) instruction sequence

DQ0

AI13735

DQ1

3456789 10 11 12 13 14 15

High Impedance

Instruction

Status

765432

MSB

M25PX32-VMP6F датащи(PDF) 30 Page - STMicroelectronics