TMPR4925 datasheet(32/590 Pages) TOSHIBA

32 / 590 page

3 General Safety Precautions and Usage Considerations

3-10

prevention of electromagnetic interference, which can facilitate taking corrective measures once

the design has been completed. These include installing shields and noise filters, and increasing

the thickness of the power supply wiring patterns on the printed circuit board. One effective

method, for example, is to devise several shielding options during design, and then select the

most suitable shielding method based on the results of measurements taken after the prototype

has been completed.

3.3.13

Peripheral circuits

In most cases semiconductor devices are used with peripheral circuits and components. The input

and output signal voltages and currents in these circuits must be chosen to match the

semiconductor device’s specifications. The following factors must be taken into account.

(1) Inappropriate voltages or currents applied to a device’s input pins may cause it to operate

erratically. Some devices contain pull-up or pull-down resistors. When designing your

system, remember to take the effect of this on the voltage and current levels into account.

(2) The output pins on a device have a predetermined external circuit drive capability. If this

drive capability is greater than that required, either incorporate a compensating circuit into

your design or carefully select suitable components for use in external circuits.

3.3.14

Safety standards

Each country has safety standards which must be observed. These safety standards include

requirements for quality assurance systems and design of device insulation. Such requirements

must be fully taken into account to ensure that your design conforms to the applicable safety

standards.

3.3.15

Other precautions

(1) When designing a system, be sure to incorporate fail-safe and other appropriate measures

according to the intended purpose of your system. Also, be sure to debug your system under

actual board-mounted conditions.

(2) If a plastic-package device is placed in a strong electric field, surface leakage may occur due

to the charge-up phenomenon, resulting in device malfunction. In such cases take

appropriate measures to prevent this problem, for example by protecting the package surface

with a conductive shield.

(3) With some microcomputers and MOS memory devices, caution is required when powering on

or resetting the device. To ensure that your design does not violate device specifications,

consult the relevant databook for each constituent device.

(4) Ensure that no conductive material or object (such as a metal pin) can drop onto and short

the leads of a device mounted on a printed circuit board.

3.4

Inspection, Testing and Evaluation

3.4.1

Grounding

Ground all measuring instruments, jigs, tools and soldering irons to earth.

Electrical leakage may cause a device to break down or may result in electric

shock.

TMPR4925 датащи(PDF) 32 Page - Toshiba Semiconductor

TMPR4925 датащи(HTML) 32 Page - Toshiba Semiconductor

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL