TMPR4925 datasheet(70/590 Pages) TOSHIBA

70 / 590 page

Chapter 3 Signals

3-12

3.2

Boot Configuration

The ADDR[19:0], UAE, SADDR10 and TDO signals can also function as configuration signals for

initially setting various functions upon booting the system. The states of the configuration signals

immediately after the RESET* or PON* signal is deasserted are read as initial values for the TX4925

internal registers. A High signal level sets a value of 1 and a Low signal level sets a value of 0. UAE,

SADDR10 and ADDR[17,16,10] are used for testing. Ensure that these pins will not set to 0.

All configuration signals are provided with internal pull-up resistors. To drive a signal Low, pull down the

corresponding pin on the board using an approx. 4.7 k

Ω resistor. Driving a signal High does not require a

pull-down resistor. Any signals defined as Reserved should not be pulled down.

Table 3.2.1 lists the functions that can be set using configuration signals. Table 3.2.2 and 3.2.3 describe

each configuration signal. Note that the functions of some pins vary with the boot memory device used.

Table 3.2.1 Functions that Can be Set Using Configuration Signals

Peripheral

Function

Functions that Can be Set

Configuration

Signal

PCICLK enable

ADDR[18]

PCI controller operating mode (satellite or host)

ADDR[15]

PCI bus arbiter selection (internal or external)

ADDR[1]

PCI controller

PCI bus master

ADDR[11]

Division ratio of SYSCLK to GBUSCLK

ADDR[4:3]

Boot device selection

ADDR[8:6]

BE[3:0]*/BWE[3:0]* function selection upon booting

ADDR[11]

Handling of the ACK signal upon booting (internal or external)

ADDR[5]

External bus

controller

Data bus width for the boot device

ADDR[13:12]

Data bus width for the boot device

ADDR[13]

Row address size for boot memory SyncFlash

BADDR[5,2]

SDRAM

controller

Column address size for boot memory SyncFlash

ADDR[11,12]

Endian setting

ADDR[14]

Others

Controlling built-in timer interrupts of the TX49/H2 core

ADDR[0]

PC trace

TDO

*1: Valid when the boot memory device is PCI and the PCIC operates in satellite mode.

*2: Valid when the boot memory device is SyncFlash.

TMPR4925 датащи(PDF) 70 Page - Toshiba Semiconductor

TMPR4925 датащи(HTML) 70 Page - Toshiba Semiconductor

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL