ZAMC4100 datasheet(76/156 Pages) RENESAS

76 / 156 page

ZAMC4100 Datasheet

January 26, 2016

These bits are automatically cleared on an over-temperature event.

These bits are automatically cleared upon SLEEP or STANDBY Mode entry.

This bit is gated in case a failure event (OC, OV, UV) is captured in an interrupt flag (see Figure 3.19).

3.11.3. ECM Driver Output Diagnostic Check

The ECM driver diagnostic circuitry is able to detect open/short failures in the driver output. The diagnostic

functionality is controlled and monitored by register ECMDIAG (Table 3.29 and Table 3.30).

Table 3.31 gives the meaning of the ECMOSF bit in the ECMDIAG register with respect to the combination of

ECMCSHEN and ECMCSLEN bits that enable the diagnostic current sources/sinks connected to the EC_M and

AC_RES pins respectively.

Table 3.29 ECMDIAG Register Bits Mapping

Name

ECMDIAG

Bit No

Bit name

Reset

Access

R/W

R/Wc

Address

0x0C

R/W = Read/Write; R = Read-only bit; U = Unimplemented, read as ‘0’;

R/Wc = Read/Write 1 to clear

The ECMOCIF is physically implemented in register ECMDIAG and mapped to IRQSTAT (Table 3.10).

Table 3.30 ECMDIAG Register Bits Description

Bit

Description

7:4

Unimplemented bits. Read as 0.

ECMCSHEN

(1): ECM high-side current source enable bit.

1 = High-side current source is enabled.

0 = High-side current source is disabled.

ECMCSLEN

(1): ECM low-side current source enable bit.

1 = Low-side current source is enabled.

0 = Low-side current source is disabled.

ECMSOF: Open/short status flag of the ECM driver. This flag is not registered; i.e., its value remains as long as the

diagnostic event takes place (see Table 3.31).

ZAMC4100 датащи(PDF) 76 Page - Renesas Technology Corp