DRV8461SPWPR datasheet(31/117 Pages) TI

номер детали	DRV8461SPWPR

подробное описание детали	DRV8461: 65 V, 3 A Stepper Motor Driver for High Efficiency and Noiseless Operation

PDF	117 Pages

Scroll/Zoom	100%

производитель	TI [Texas Instruments]

домашняя страница	http://www.ti.com

Logo

31 / 117 page

7.3.9.1 Slow Decay

BLANK

OFF

DRIVE

TRIP

BLANK

DRIVE

OFF

BLANK

DRIVE

BLANK

DRIVE

TRIP

BLANK

DRIVE

OFF

Figure 7-12. Slow Decay Mode

During slow decay, both the low-side FETs of the H-bridge are turned on, allowing the current to be recirculated.

Here are the points to consider when selecting slow decay mode -

• Slow decay exhibits the least current ripple of the decay modes for a given tOFF.

• However on decreasing current steps, slow decay will take a long time to settle to the new ITRIP level because

the current decreases very slowly.

– If the current at the end of the off time is above the ITRIP level, slow decay will be extended for another off

time duration and so on, till the current at the end of the off time is below ITRIP level.

• In cases where current is held at the same level for a long time (no STEP input), or the target regulation

current level is low, or at very low stepping speeds, slow decay may not properly regulate current because

the back-EMF across the motor windings may be very small to discharge the current during the off time. In

this state, motor current can rise very quickly, and may require a large off time. In some cases this may cause

a loss of current regulation, and a more aggressive decay mode is recommended.

www.ti.com

DRV8461

SLOSE98 – DECEMBER 2022

Submit Document Feedback

Product Folder Links: DRV8461

DRV8461SPWPR датащи(PDF) 31 Page - Texas Instruments