S70FS01GS datasheet(28/141 Pages) CYPRESS

28 / 141 page

S70FS01GS

Document Number: 002-03833 Rev. *C

Page 28 of 141

4.5.3

Extended

Applicable within operating

40 °C to +125 °C range.

Notes:

1. Typical values are at TAI = 25°C and VDD = 1.8V.

2. Outputs unconnected during read data return. Output switching current is not included.

4.5.4

Active Power and Standby Power Modes

The device is enabled and in the Active Power mode when Chip Select (CS#) is Low. When CS# is high, the device is disabled, but

may still be in an Active Power mode until all program, erase, and write operations have completed. The device then goes into the

Standby Power mode, and power consumption drops to ISB.

A Deep Power Down (DPD) mode is supported by the FS-S Family devices. If the device has been placed in DPD mode by the DPD

(B9h) command, the interface standby current is (IDPD). The DPD command is accepted only while the device is not performing an

embedded algorithm as indicated by the Status Register-1 volatile Write In Progress (WIP) bit being cleared to zero (SR1V[0] = 0).

While in DPD mode the device ignores all commands except the Release from DPD (RES ABh) command, that will return the device

to the Interface Standby state after a delay of tRES.

Table 4.5

DC Characteristics — Extended

Symbol

Parameter

Test Conditions

Min

Typ

(1)

Max

Unit

VIL

Input Low Voltage

0.5

0.3

 VDD

VIH

Input High Voltage

0.7

 VDD

VDD+0.4

VOL

Output Low Voltage

IOL = 0.1 mA

0.2

VOH

Output High Voltage

IOH = –0.1 mA

VDD - 0.2

ILI

Input Leakage Current

VDD=VDD Max, VIN=VIH or VSS, CS# = VIH

±8

µA

ILO

Output Leakage Current

VDD=VDD Max, VIN=VIH or VSS, CS# = VIH

±8

µA

ICC1

Active Power Supply

Current (READ) (2)

Serial SDR@50 MHz

Serial SDR@133 MHz

Quad SDR@133 MHz

Quad DDR@80 MHz

ICC2

Active Power Supply

Current (Page Program)

CS#=VDD

100

ICC3

Active Power Supply

Current (WRR or WRAR)

CS#=VDD

100

ICC4

Active Power Supply

Current (SE)

CS#=VDD

100

ICC5

Active Power Supply

Current (BE)

CS#=VDD

100

ISB (Industrial Plus)

Standby Current

IO3/RESET#, CS#=VDD; SI, SCK = VDD or VSS,

Industrial Plus Temp

140

600

µA

IDPD

Deep Power Down Current

IO3/RESET#, CS#=VDD; SI, SCK = VDD or VSS,

Industrial Temp

500

µA

IPOR

Power On Reset Current

IO3/RESET#, CS#=VDD; SI, SCK = VDD or VSS

160

S70FS01GS датащи(PDF) 28 Page - Cypress Semiconductor

S70FS01GS датащи(HTML) 28 Page - Cypress Semiconductor

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL