TSB41BA3APFP datasheet(45/66 Pages) TI

45 / 66 page

TSB41BA3A

IEEE 1394b THREEPORT CABLE TRANSCEIVER/ARBITER

SLLS618B − JUNE 2004 − REVISED AUGUST 2004

POST OFFICE BOX 655303

• DALLAS, TEXAS 75265

PRINCIPLES OF OPERATION

transmit (continued)

The sequence of events for a normal packet transmission is as follows:

(a) Transmit operation initiated. The PHY asserts grant on the CTL lines followed by idle to hand over control

of the interface to the link so that the link may transmit a packet. The PHY releases control of the interface

(that is, it places its CTL and D outputs in a high-impedance state) following the idle cycle.

(b) Optional idle cycle. The link may assert at most one idle cycle preceding assertion of either hold or transmit.

This idle cycle is optional; the link is not required to assert idle preceding either hold or transmit.

hold cycle(s) are optional; the link is not required to assert hold preceding transmit.

(d) Transmit data. When data is ready to be transmitted, the link asserts transmit on the CTL lines along with

the data on the D lines.

(e) Transmit operation terminated. The transmit operation is terminated by the link asserting hold or idle on the

CTL lines. The link asserts hold to indicate that the PHY is to retain control of the serial bus in order to

transmit a concatenated packet. The link asserts idle to indicate that packet transmission is complete and

the PHY may release the serial bus. The link then asserts idle for one more cycle following this hold or idle

cycle before releasing the interface and returning control to the PHY.

(f) Concatenated packet speed-code. If multispeed concatenation is enabled in the PHY, then the link asserts

a speed-code on the D lines when it asserts hold to terminate packet transmission. This speed-code

indicates the transmission speed for the concatenated packet that is to follow. The encoding for this

concatenated packet speed-code is the same as the encoding for the received packet speed-code (see

Table 21). The link may not concatenate an S100 packet onto any higher-speed packet.

(g) After regaining control of the interface, the PHY asserts at least one idle cycle before any subsequent status

transfer, receive operation, or transmit operation.

(e)

(d)

(c)

(b)

(a)

D0–D7

CTL0, CTL1

SYSCLK

Link Controls CTL and D

PHY High-Impedance CTL and D Outputs

Figure 18. Cancelled/Null Packet Transmission

TSB41BA3APFP датащи(PDF) 45 Page - Texas Instruments