CS8952T datasheet(16/86 Pages) CIRRUS

16 / 86 page

DS206TPP2

CS8952T

CrystalLAN™ 100BASE-X and 10BASE-T Transceiver

CIRRUS LOGIC ADVANCED PRODUCT DATABOOK

RESET - Reset. Input, Pin 15.

This active high input initializes the CS8952T, and causes the CS8952T to latch the input

signal on the following pins: COL/PHYAD0, CRS/PHYAD2, RX_ER/PHYAD4/RXD4,

10BT_SER, BP4B5B, BPALIGN, BPSCR, ISODEF, REPEATER, RXD1/PHYAD1, and

RXD3/PHYAD3.

XTAL_I - Crystal Input, Pin 96.

XTAL_O - Crystal Output, Pin 97.

A 25 MHz crystal should be connected across pins XTAL_I and XTAL_O. If a crystal is not

used, a 25 MHz CMOS level clock may be connected to XTAL_I and XTAL_O left open.

NOTE: The XTAL_I pin capacitive load may be as high as 35pF. Any external clock source connected to this pin

must be capable of driving larger capacitive loads.

RSVD - Reserved. Pins 74, 75, 76, 77, 84, 98, and 99.

These seven pins are reserved and should be tied to VSS.

VDD_MII - I/O Pad Power. Pins 21, 34, and 66.

These pins provide power to all CS8952T digital I/O pads. Typically VDD_MII will be either

+5V or +3.3V.

VDD - Core Power. Pins 2, 11, 19, 40, 54, 79, 82, 88, 89, 94, and 100.

These pins provide power to the CS8952T core. Typically, VDD should be +5V.

VSS - Pins 1, 3, 10, 12, 13, 18, 20, 22, 35, 39, 41, 53, 55, 62, 65, 78, 83, 85, 87, 90, 93, and 95.

These pins provide a ground reference for the CS8952T.

CS8952T датащи(PDF) 16 Page - Cirrus Logic