S29GL01GP datasheet(45/81 Pages) SPANSION

45 / 81 page

October 22, 2012 S29GL-P_00_A14

S29GL-P MirrorBit® Flash Family

Data

She e t

8.2.1

Dynamic Protection Bits

Dynamic Protection Bits are volatile and unique for each sector and can be individually modified. DYBs only

control the protection scheme for unprotected sectors that have their PPBs cleared (erased to “1”). By issuing

the DYB Set or Clear command sequences, the DYBs are set (programmed to “0”) or cleared (erased to “1”),

thus placing each sector in the protected or unprotected state respectively. This feature allows software to

easily protect sectors against inadvertent changes yet does not prevent the easy removal of protection when

changes are needed.

Notes

1. The DYBs can be set (programmed to “0”) or cleared (erased to “1”) as often as needed. When the

parts are first shipped, the PPBs are cleared (erased to “1”) and upon power up or reset, the

DYBs can be set or cleared depending upon the ordering option chosen.

2. If the option to clear the DYBs after power up is chosen, (erased to “1”), then the sectorsmay be

modified depending upon the PPB state of that sector (see Table 8.2).

3. The sectors would be in the protected state If the option to set the DYBs after power up is chosen

(programmed to “0”).

4. It is possible to have sectors that are persistently locked with sectors that are left in the dynamic

state.

5. The DYB Set or Clear commands for the dynamic sectors signify protected or unprotectedstate of

the sectors respectively. However, if there is a need to change the status of the persistently locked

sectors, a few more steps are required. First, the PPB Lock Bit must be cleared by either putting

the device through a power-cycle, or hardware reset. The PPBs can then be changed to reflect the

desired settings. Setting the PPB Lock Bit once again locks the PPBs, and the device operates

normally again.

6. To achieve the best protection, it is recommended to execute the PPB Lock Bit Set command early

in the boot code and protect the boot code by holding WP#/ACC = VIL. Note that the PPB and DYB

bits have the same function when WP#/ACC = VHH as they do when ACC =VIH.

8.3

Persistent Protection Bit Lock Bit

The Persistent Protection Bit Lock Bit is a global volatile bit for all sectors. When set (programmed to “0”), it

locks all PPBs and when cleared (programmed to “1”), allows the PPBs to be changed. There is only one

PPB Lock Bit per device.

Notes

1. No software command sequence unlocks this bit unless the device is in the password protection

mode; only a hardware reset or a power-up clears this bit.

2. The PPB Lock Bit must be set (programmed to “0”) only after all PPBs are configured to the

desired settings.

8.4

Password Protection Method

The Password Protection Method allows an even higher level of security than the Persistent Sector Protection

Mode by requiring a 64-bit password for unlocking the device PPB Lock Bit. In addition to this password

requirement, after power up and reset, the PPB Lock Bit is set “0” to maintain the password mode of

operation. Successful execution of the Password Unlock command by entering the entire password clears the

PPB Lock Bit, allowing for sector PPBs modifications.

Notes

1. There is no special addressing order required for programming the password. Once the Password

is written and verified, the Password Mode Locking Bit must be set in order to prevent access.

2. The Password Program Command is only capable of programming “0”s. Programming a “1” after a

cell is programmed as a “0” results in a time-out with the cell as a “0”.

3. The password is all “1”s when shipped from the factory.

4. All 64-bit password combinations are valid as a password.

S29GL01GP датащи(PDF) 45 Page - SPANSION

S29GL01GP датащи(HTML) 45 Page - SPANSION

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81

датащи скачать

ссылки URL